Question about Sony Car Amplifiers

1 Answer

Wiring diagrams looking for the wiring diagram for a sony xplod 4ch 600w amp. number xm-zr604

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Amp xm-ZR604 keeps going into protect mode


check the ground and the positive wires to make sure that they are getting good continuity. if your amp is too small for the speakers you are pushing this will also put the amp into protect mode

Feb 09, 2011 | Sony - XM-ZR604 4/3 channel car amplifier

1 Answer

Need help installing my x-plod xm-zr604 amp in my car and am not sure about how to hook up the speakers need wiring diagram


http://www.the12volt.com/caraudio/woofer_configurations.asp
Go here and enter their specs, and it will tell you the ways to wire them. (Even though they say subwoofers, it works for speakers to.

Oct 07, 2009 | Car Amplifiers

1 Answer

I have a 04 silverado with factory bose stereo. I have installed a Xplod xm-zr604 and the sub is playing but it will not crank up. Its as if the volume is very low.I have tie in after the factory amp for...


If you dont have a line level converter with adjustable output - get one.

Your amplifier only amplifies the signal it gets - and if its a very low voltage - you wont get as much output from the ampifier.

I always recomend PAC converters. They are a little more expensive - but are #1 adjustable, and #2 they also make one with voltage sensing. You wire up a positive power source, and when it detects voltage from the speaker wires - it will send a remote turn on to your amplifier. (MTX has this technology built in to its amplifiers)

No more crawling under the dash or removing the factory radio!!!

Thanks for using FixYa - a very Helpful rating is appreciated for answering your FREE question.

Jul 23, 2009 | Sony Xplod XM-554ZR Car Audio Amplifier

1 Answer

My 600w power amp XM-554ZR wont turn on.Its an Xplod 4/3 channel, and it was working fine...until yesterday that i checked it. the green light was off.


open it n there is a red wire look at the end of it n u would see a black celinder with a with a white strip on it change that part if it is burn

Jul 14, 2009 | Sony Xplod XM-554ZR Car Audio Amplifier

1 Answer

Can this amp xm-2252hxcan be use to drive a 800 watts sony xplod


yep, you'll be safe. It's capable of delivering 225W x 2 RMS and 600W x 1 RMS into 4 Ohm loads.

Jun 18, 2009 | Sony XM-2252HX Car Audio Amplifier

1 Answer

Xplod amp will not get off of power protection mode


if the protect light stays on the amp is blown or has flawed components and is only repairable by expirenced sony tech

May 18, 2009 | Sony Xplod XM-554ZR Car Audio Amplifier

1 Answer

Bridge a two channel amp


i the search bar type in....subwoofer wiring diagram....then go to crutchfield and it shows you your options.......

Jan 28, 2009 | Sony Xplod XM-554ZR Car Audio Amplifier

Not finding what you are looking for?
Car Amplifiers Logo

Related Topics:

920 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Car Amplifiers Experts

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

yadayada
yadayada

Level 3 Expert

60867 Answers

Are you a Sony Car Amplifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...