Question about Mitsubishi WD-52725 52". Rear Projection HDTV

3 Answers

Mitsubishi DLP overheating

I have a MItsubishe DLP model WD-62927 and during the last 2 weeks a massage comes on the screen that TV will shut down soon to check ventilation. There is no blockage to ventilation and TV does turn off, LED turns amber and remains that way for approximately 15 minutes, after that TV will turn on again TV goes on green light stays on no video about 10 seconds then goes to red lamp light

Posted by on

  • Anonymous Mar 14, 2014

    screen blinks a loud noise from the fan comes on then the tv shuts down

  • Anonymous Mar 22, 2014

    I have a Mitsubishi wd-62531 and have replaced the bulb 3 times in 2 weeks, now the tv will work for about 20 minutes. Then the tv will shut off and get a solid red light. After about a minute I can turn the tv back on and it works fine for another 20 minutes then it happens all over again.

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 38 Answers

Mitsubishi has problems with the thermal sensor going bad. They extended the warranty for several sets. The sensor is right by the lamp. Call mitsubishi and insist they do something for you. If you keep playing your set, the bulb could also be at risk. I would think your set is covered being a 62" set. Good-luck and be sure to act ASAP.

Posted on Dec 24, 2008

  • Ben N Ute Channell Jr.
    Ben N Ute Channell Jr. Mar 09, 2014

    do you have contact phone number cant find one?

×

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

There is a third fan behind the intake fan shraud it points at the light clean it with qtips and canned air good luck

Posted on Aug 03, 2012

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My lamp went out, replaced it, worked for two days and the red light for the lamp came on again, cleaned the back for good air ventilation, any other ideas?????????

Posted on Apr 30, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Blinking green power light on WD65737 for a minute or so then shut down, Will also go to welcome screen and then shut down


Those blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://homenol.blogspot.com/
http://electronicshelponline.blogspot.com/
If blinks continue without any pause, the main board is faulty.

Jan 13, 2017 | Mitsubishi WD65737 65 inch DLP 1080p HDTV

1 Answer

E500i-B1 won't come on.


Suspect a failing power supply

Jan 13, 2017 | Televison & Video

1 Answer

EMERSON 55 INCH TV MODEL: LF551EM5 SERIAL: DS2A1433113216


Sounds like The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts. http://electro-medical.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size.

Jan 10, 2017 | Emerson Televison & Video

1 Answer

I have a Emerson model LF391EM4 flat screen that when turned ON shut itself off after apx 10 seconds. It has never done this before, what can I try to do?


REBOOT IT BUT HOLDING DOWN ON THE POWER AND TURN IT BACK BUT HOLFD IT DOWN FOR ABOUT TEN SECONDS AND THEN TURN IT BACK ON

Jan 09, 2017 | Emerson Televison & Video

2 Answers

Vertical lines on my plasma tv


If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Line faults & possible causes to LCD & Plasma screen are given with illustrations. You can get an idea about the fault to an extent. Faults to all LCD & Plasma screen are similar, irrespective of its brand and screen size.
Search the site by type in the "BRAND NAME" of your device; (Exclude the model number), in the "Search box at the top right of the display window of the Homepage" to get gathered related posts

Jan 08, 2017 | Samsung Televison & Video

1 Answer

My sony wega kf-50E200A tv keeps turning off. during each cycle the green light blinks 42 times and the tv comes on again for about 3 minutes and it happens all over again


More than likely the power supply is defective, but without testing and the repair manual that is just a guess, you make the decision to replace or repair the TV.

Jan 07, 2017 | Sony KF-50E200A TV Lamp with Housing

4 Answers

LG 26LH2000 television. Last 2 days when I turned my TV on there was only sound, and black screen.


back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis. http://electronicshelponline.blogspot.com/ To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced. To some models of sets, all these section circuit will be integrated at its main board. If this is the case, you have to replace the main board.
26359174-wxmxxsggneevie4j1gyznoid-1-0.jpg

Nov 16, 2016 | LG 26LH2000 26 in. HDTV LED TV

1 Answer

Samsung DLP HLS4266W


Check the fittings of the color wheel. Refer this site for more details.
http://electronicshelponline.blogspot.com/

May 17, 2013 | Televison & Video

Not finding what you are looking for?
Mitsubishi WD-52725 52". Rear Projection HDTV Logo

1,539 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1207 Answers

The Knight
The Knight

Level 3 Expert

71608 Answers

Jaime Hernandez

Level 3 Expert

2291 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...