Question about Eureka 5892AVZ Bagless Upright Cyclonic Vacuum

1 Answer

Eureka 5892AVZ Bagless Upright Vacuum has become extremely noisy

I am looking for a parts diagram so that I can become familiar with the vavuum before I disassemble the machine down to the motor to see if the fan blade has been damage or has something stuck in it. Vacuum has had hard use over the past couple of years and has vacuumed up a number of objects not intended to be ,.sucked up. Any information you can pass on to me would be greatly appreciated. Thanks Bruce

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 75 Answers

This link will give you a copy of the owners manual that will help you some
http://www.eureka.com/service/manuals/80244.pdf
Hope this helps. biigg53566

Posted on Dec 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Eureka 5892 BVZ-1 vaccum has very little suction. I checked hoes and emptied cup, and made sure filter is not dusty.


There are probably three filters, one on the back of the dust collection bin, one under the dust collection bin, and one where the air exits the vacuum, check all three.
Gary

Mar 04, 2011 | Eureka 5892AVZ Bagless Upright Cyclonic...

1 Answer

How do I locate and find each of the filters?


The foam & filter assembly is behind the clear door with the latch you pull up on, located above the dirt cup. The hepa filter is on the right side of vacuum as you are facing it from front.

Sep 04, 2010 | Eureka 5892AVZ Bagless Upright Cyclonic...

1 Answer

What causes a vacuum to make lots of dust and throw back out what it vacuumed


It sounds like the airducts that lead to your dirt chamber are clogged. The dirt can't get through to the dirt cup so it spits it back out and blows dust everywhere.

Nov 27, 2009 | Eureka 5892AVZ Bagless Upright Cyclonic...

2 Answers

Handle gets very hot on my 5892BVZ vac


i have a 1998 chrysler sebring convertible stop starting by the ignition switch,we changed starter,ignition switch been changed,changed starter relay,trace the wire haven't found a broke are burned place in it,checked igniton fuse its good,didn't see a linkable fuse

Sep 23, 2009 | Eureka 5892AVZ Bagless Upright Cyclonic...

1 Answer

Problems with Eureka 5892AVZ Bagless Upright Cyclonic Vacuum? the cat hair seems to plug up the filter instead of goint to the canister


You may be using the wand/hose without an attachment on it. The attachments on my dyson always allow some air to flow to by, it may be the same on the Eureka. If air flow is completely stopped the cyclone will shut down and then the hair/dust/whatever will flow to the filter. So don't let the air flow be completely shut off during use.

May 15, 2009 | Eureka 5892AVZ Bagless Upright Cyclonic...

1 Answer

Motor is noisy like there is something stuck in it. I am looking for the service manual so I can see how to take it apart/


Hi Generally modern upright vacs don't have screws that you can undo to get into the motor and most Electrolux/Eureka models have sealed units. I suggest looking at the sole plate where the roller brush is, check for anything clogging the main dust channel and then remove the hoses. Also take out the filters and give them a good clean, washing them are good but you must let them dry (or put in a low temp tumble dryer in a pillowcase with a towel) out.
You'd have to check out Eureka's customer services for an imploded service manual. Check on their website if nothing else works.

Mar 27, 2009 | Eureka 5892AVZ Bagless Upright Cyclonic...

1 Answer

No upright suction


This means that you have something plugging the main camber where the dirt enters through beater bar head.check that out. biigg53566

Jun 24, 2008 | Eureka 5892AVZ Bagless Upright Cyclonic...

1 Answer

Hose suction Eureka theboss smartvac


There has to be a clog in the hose, Unhook the hose and drop like a big marble in it to see if it comes out the other end.

May 10, 2008 | Eureka 5892AVZ Bagless Upright Cyclonic...

1 Answer

Vacuum doesn't go into carpet mode


If the model number is 5892AVZ, either the brush roll is bad or the brush roll motor isn't coming on to drive the brush roll. There is a circuit breaker, make sure it didn't trip, reset it if it has.

Jan 31, 2008 | Eureka 5892AVZ Bagless Upright Cyclonic...

Not finding what you are looking for?
Eureka 5892AVZ Bagless Upright Cyclonic Vacuum Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eureka Vacuums Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18297 Answers

Ryan S
Ryan S

Level 2 Expert

328 Answers

Jim Parker
Jim Parker

Level 3 Expert

1040 Answers

Are you an Eureka Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...