Question about Philips 37MF321D 37 in. LCD Television

1 Answer

TV WONT COME ON

WHEN POWERING ON THE TV IT RETURNS BACK INTO STANDBY THE PROBLEM STARTED TWO WEEKS AGO AND AT FIRST IT WOULD COME ON AFTER SEVERAL ATTEMPTS BUT NOT NOW

Posted by on

  • 8 more comments 
  • Anonymous Dec 06, 2008

    goes into standby and then powers off

  • dave1direct Dec 21, 2008

    I have a similar problem, i can hear the power come on but the screen remains black. Did you ever find a solution to your problem?

  • alojas Dec 24, 2008

    I have been having the same problem, first it was just about 10-15 sec that it wouldn't come on...now 3 weeks later it is almost 5 min before the picture comes on, and the sound on certain channels will not work unless you turn the tv off and on real quick...seems like TV is going downhill fast and it is only a little over a year old...

  • Anonymous Jan 01, 2009

    Exactly the same problem, do you think it's worth paying an engineer to repair it?

  • Anonymous Jan 11, 2009

    any solutions? is there someone to call?

  • carled Jan 11, 2009

    Mine is stuck in power up mode as well...it will not come on.

  • laff_aloud Jan 14, 2009

    same problem here as well

  • GoOwnIt Jan 18, 2009

    I brought mine into the shop and they wanted to replace the entire circuit board to the tune of about $350.  Instead, I went to Costco and bought a Vizio 32" for $379 with a two year Costco Warranty.


    I wish I could find someone to work on it since I hate to junk it if it is fixable or part it out for someone else.

  • dennis111111 Jan 23, 2009

    July 08 Purchase and it bit the dust!!! Won't power on (dead). Tried switching outlets - no major event caused it. Who do I call?

    my e-mail is dennis11111117@yahoo.com

  • mbsimonds May 11, 2010

    If anyone in the CT area want's to junk theirs I will take them.



    MBSimonds AT aol DOT com

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had the same problem. Take the back off the TV.....disconnect power supply first....
You probably will find a cooling fan on the right side that is froze up. Get a Strong vacuum, clean it until it turns freely. The TV will now work unless you have other problems.

Posted on Feb 12, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power Problem with Fisher RS 9015


Glad it helps, thanks also for choosing Fixya for assistance!

Aug 13, 2012 | Audio Players & Recorders

1 Answer

Unit stays on standby


The only thing I can find in the manual (link below) is to remove the power cord for a few minutes & try powering on from the "Standby ON" button, also set the "source" to anything other than TV. http://www.p4c.philips.com/files/l/lx3600d_25/lx3600d_25_dfu_eng.pdf

Jul 07, 2007 | Philips LX3600D System

1 Answer

My Vizio M261VP was purchased three weeks ago. A week ago, the audio on channels other than the digital HD channels are very low. For example, an analog channel or Netflix via the VIA the volume needs to...


I would return the Set ASAP! TV has a factory defect,take it back and get you another TV,
and If it happens to do the Same thing Then Company might have more then several TVs that must be returned to Factory.
I had a Friend of mine who bought a new Tv got it home it had a problem she took back 3 TVs and they all where doing the same thing.She just got her money back and went to another store.
But they did Offer Her Another Set from company.

Feb 27, 2011 | Vizio M261VP 26" LCD TV

1 Answer

I was watching a dvd on my week-old Sony Bravia XBR-52HX909 for the past three hours when the screen suddenly went blank. The standby indicator light in red started blinking. I attempted to turn on the...


This tv only a week olds,should never having this problems already.The tv should be return and get a new tv for the replacement,this tv have tv Tuner signal board or tv power supply board distrubution problems.Even when the store test it out it work,don't take that tv back.Insit they give a new tv for the replacement.

Dec 13, 2010 | Sony Bravia XBR-52HX909 52 in. LCD HDTV

1 Answer

Sony kv36hs500 tv, suddenly no power, no standby lights, no sound


U check the power source?Take the tv aparts,check or replaced the power fuse,might get lucky.Not,than sorry,this tv can't be repair,without replacing electronic's componnents parts.Hire the same shop to do the repair.Ur tv power ICS inverter are dead.

Jun 15, 2010 | Sony FD Trinitron WEGA KV-36HS500 36" TV

3 Answers

WHEN I TURN ON MY L32 I GET NO PICTURE. I GET BLACK SCREEN THEN LOTS OF COLOR, REDS ,BLUE ,ALL COLORS IN DIFFERENT PATERNS THAT KEEP CHANGING. SOUND IS PERFECT AND I CAN CHANGE CHANNELS AND VOLUMEAND...


It sounds to me like it's stuck in service mode.There is a button combination with the remote to return it to normal. I would call Vizio support and they should be able to help you.

I think it's a combination like [volume -], [channel -] and power but I could be wrong.

Dec 19, 2009 | Vizio L32 32 in. LCD HDTV

1 Answer

Stand by time is flashing tv will not start


no the tv has no battery for memory.the memory is supplied by the 5 volt standby.the tv must be plugged in to maintain the 5 volts to keep its memory.

Jul 18, 2009 | Sony FD Trinitron WEGA KV-34HS420 34" TV

1 Answer

New Sharp Aquos LC37X20E. After 30 mins turns itself off to standby and comes back on after 2-5mins (even though the automatic return to stanby has been set to "disable"). Eventually after...


According to Sharp it is a software problem. Engineer came, installed software update ,10 minute job.....TV worked fine for 1/2 day unfortunately: Then images turned black and white in all channels TV turned itself off, and stanby and OPC buttons started flashing. When TV came back on its own 10 mins later , screen had 2 large square staines superimposed in image (as if it was a burnt screen)...Engineer will be back next week...all quite sad really for a new TV.....will keep u posted

Jul 03, 2008 | Sharp Televison & Video

1 Answer

LD 37LC7D


This set has a modification that needs to be done. It will also start turning on by itself and changing channels rapidly. It's two weeks old. Take it back to the Retailer or if that is not an option contact LG at 1-800-243-0000 to get a local servicer in your area.

Aug 18, 2007 | LG 42LC2D 42 in. LCD HDTV

Not finding what you are looking for?
Philips 37MF321D 37 in. LCD Television Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philips Televison & Video Experts

The Knight
The Knight

Level 3 Expert

72670 Answers

matt martin
matt martin

Level 3 Expert

1207 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Are you a Philips Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...