Question about Hitachi 43GX10B 43" Rear Projection Television

1 Answer

Red line There is a red line on the top left corner of of the screne. I went to the digital aray screne and the red + marker was out about 8in below the green and blue. I would like to fix this my self. Any help I can get would be great. A repair guy said the bulb could be out of alinement.Do you need tools to ajust the bulb?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,284 Answers
Re: Red line

Once in the Didigtal Array screen, can you move the red in that corner horizontally and vertically? You should be able to do this with the remote control, no special tools needed for this model. If you can't move it then you will need to replace your convergence output IC's they are location numbers IK04 and IK05 and are usually generic part numbers STK392-110.

Posted on Feb 13, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

I have a Hitachi 46F500 tv and the red crt bowed

I just had the convergence replaced and have a great picture

Aug 16, 2009 | Hitachi 46F500 46" Rear Projection...

1 Answer

Tv red light blinks off and on. Unplugged for an hour Tv worked for 10 monutes and then picture went to top left corner and got blurry. TV HAS BLINKING RED LIGHT AGAIN.

Replace Both of your convergence ICs one is bad ,but replace both STKs big black ICs also CK two resistors in same circuit 2.7ohms

Aug 11, 2009 | Samsung HCM4215W 42" Rear Projection...

1 Answer

Cant get the Multipoint red/blue set right

Most likely your convergence circuit needs repair, there are 2 large IC chips with heat sinks (labeled STKxxx -XXX) and possibly depending on model a resistor or fuse may have went with it. 95% of the time this is all it is. It could cost $300-400 to have someone repair it.

May 04, 2009 | Projection Televisions

1 Answer

Sony rear projection screen is red then tv shuts off

Can be 1 of 2 things. 1st the red tube just needs the voltage to it turned down. In the front of TV (you have to remove the lower front half of TV to access it) is a plastic square with 6 knobs. The from left to right top knobs control focus for blue,green red. The bottom knobs control voltage to each tube in same order (so lower right knob for red) turn SLOWLY to left to reduce voltage until excessive red and lines go away. If you over turn left or right set will turn off. If that does not fix it or if lines reappear then option 2 is that red picture tube is failing outright and needs replacement.

Jan 29, 2009 | Sony KP-57WS500 57" Rear Projection...

1 Answer

Red is out of alignment

when i go to convergence and align the white cross with the blue its ok ,but when i try the red it doesnt line up and if l get it close enough it get misaligned only with the red ,green and blue fine

Nov 15, 2008 | Mitsubishi WS-65809 65" Rear Projection...

1 Answer

I have a phillips rear projection 51PW9303 red and green lines showing in the left corners and red line thru middle of screen, bottom of screen shadows and so does left top corner if numbers and...

sounds like youre describing a convergence problem. Do the letters look like theyre 3D? If so you will need to replace both Convergence ICs STK392-120 you can get replacements at the following link and they include installation instructions with pictures plus gree tech support. heres the link.

Apr 24, 2008 | Projection Televisions

1 Answer

Red line across the top

Uh oh, time for convergence board work...accordianman

Jan 12, 2008 | Mitsubishi WS-65869 65" Rear Projection...

1 Answer

Red/green drooping L top corner

i have found when samsangs convergence are out of range perfect focus will fail. if the are out of range a technician will try to adjust the set in service mode. store these values and then this will be the base for the perfect focus. If the set has a bad convergence cuircit then they have to be replaced.

Nov 05, 2007 | Samsung HCN653W 65" Rear Projection...

1 Answer

Red lines taking over my T,V

Nov 26, 2006 | Samsung HCM5525W 55" Rear Projection...

Not finding what you are looking for?
Hitachi 43GX10B 43" Rear Projection Television Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Hitachi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides