Question about Maytag MER4351A Electric Kitchen Range

1 Answer

Stove keeps shutting off by itself

The burners work on my electric range, but I'm having problems with my stove. Everytime I push "bake", it will start to heat up then beep once and shut off. The bake light will also go off. Any info will help. I've unplugged the stove to see if that would help to reset, and I had no luck. Thanks, Matt

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer
Re: Stove keeps shutting off by itself

HI I have a different brand, but this same thing was happening to our oven, I had to have a repairman replace the temperature sensor in the oven. Apparently it was reading the temperature as like 300 degrees higher than it actually was so it was shutting off (I guess as a safety mechanism). Hope this helps. Good luck.

Posted on Feb 12, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

My whirlpool electric stove not turning on

Make sure it is plugged in and you have power to your house.If everything is dead check your fusebox for blown fuses if you have circuit breakers reset the breaker for the stove by turning it off then back on. If the burners on the top work,but the oven won't you probably have a burned out bake element .To change this turn off power to the stove and unplug remove 2 or 3 screws holding the bake element and remove the wires to the element by loosing the screws on the terminals note sometimes bake elements plug in in this case just unplug. Reverse process to install. Reapply power and test.

Aug 06, 2014 | Whirlpool Stove / Oven / Range Electric...

1 Answer


I sounds like an issue with the pilot light. Our stove does the same. Sorry that's not much help

Jul 23, 2012 | Jenn-Air JES9750 Electric Kitchen Range

1 Answer

My stove will not heat using bake but will work for broiler so I know it is not a heating problem. Help!

this model is not a dual fuel, and you do have a heating problem, there are two burners, a bake burner and a broil burner, both have ignitors. You have a bad bake ignitor.

Sep 27, 2009 | Maytag MGR5775QDS Dual Fuel (Electric and...

1 Answer

Whirpool Imperial Series Stove turns off while I'm trying to bake

there is a control board just behind the clock. on that board is an omron g2rl-1a-e-cf, 9vdc, 16/250vac type relay. i replaced that relay with an equivalent wired in one and that fixed the problem.

Jun 19, 2009 | Whirlpool GR460 Electric Kitchen Range

1 Answer

Stove top burners and lower baking element not heating up

If all the elements are dead, check for blown fuses/tripped circuit breakers. There may be some in the range unit itself in addition to your electrical service panel. If one element is completely dead on all heat settings, the control is probably bad or there is a broken wire. If it is stuck on high for all control settings or is erratic, the control is bad - replacements are readily available and easily installed.
On ranges with push button heat selection, a pair of heating elements are switched in various combinations across 120 and/or 240. If some heat settings do not work, the most likely cause is that one of the heatings elements is burnt out although a bad switch is also possible. Kill power to the range and test the heating elements for continuity with resistance meter or multimeter.

For the lower baking element:
Again, check for blown fuses in the oven or tripped circuit breakers. The remove any wiring to the bottom element and test for resistance. If you get no reading (or a very high resistance) then your element is dead.

May 09, 2009 | Kitchen Ranges

2 Answers

Stove won't heat

Oven was working, I had it on pre-heat, then I turned on the stove top, but the burners won't heat. When I turn on the stove top the stove makes a short BUZZ noise and the clock area lights up, when the burner is turned off all the lights go out. Please help, food prepared.
Thank You

Dec 02, 2008 | Frigidaire FEF336BC Electric Kitchen Range

1 Answer

Frigidaire Stove elements not working

First thing I would check is see if you are getting 220 volts to the stove.  Must be a constant 220.  Let me know what you find.

Oct 15, 2007 | Frigidaire FED300AS Electric Kitchen Range

Not finding what you are looking for?
Maytag MER4351A Electric Kitchen Range Logo

Related Topics:

339 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Kitchen Ranges Experts


Level 2 Expert

283 Answers


Level 3 Expert

2963 Answers


Level 2 Expert

236 Answers

Are you a Maytag Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides