Question about Panasonic ER 240 Beard Trimmer

2 Answers

Pansonic er200 need new rechargable battery

Can it be replaced and can it be done by owner. Where would it be purchased.
Thanks

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 641 Answers

Two AA rechargable batteries can be used, and yes you can replace them yourself.

Posted on Mar 04, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I am interested to purchase your ER-200. do you buy it?
Write mi conditions at loianes@iol.it
thanks

Posted on Oct 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Do I have to change lithe on battery in my whal cordless hair clippers. They have started snagging hair not holding charge. I have had them about 8 years & lost manual .


8 years is pretty good for a rechargeable battery, I would say yes the battery needs to be replaced, although it may be cheaper to purchase a new shaver ?

Feb 27, 2015 | Shavers

1 Answer

How to solder electric wires to nicd batteries


First, purchase whatever battery you need with solder terminals on it. They are called tabs. I use megabatteries.com when I am purchasing "special" batteries. Get battery number off the old battery. If it looks like an AA, the number will be something like 22000, 14430, 14500. Enter that number into the Search feature and the available replacements should be listed. It will cost you $5 to $20 depending on several factors. I usually purchase other std. rechargeable batt. to spread my shipping cost. I realize this reply doesn't tell you "how to solder". That is easy once you purchase a battery with tabs.

Feb 25, 2013 | Shavers

1 Answer

I HAVE A PHILLIPS SHAVER MODEL 5890 AND HAVE PURCHASED NEW RECHARGEABLE BATTERIES. HOW DOES ONE REMOVE THE OLD BATTERIES AND FIT THE NEW ? I HAVE OPENED UP THE SHAVER BUT THE EXISTING BATTERIES SEEM WELL...


The batteries are soldered into place. You will need a soldering iron and electrical solder to replace them. Unsolder the old batteries from the circuit board and solder in the new batteries

If you are not able to do this repair yourself, shaveroutlet.com can do it for you. See information at the link below

http://shaveroutlet.com/shaver-replacement-parts/professional-battery-replacement-for-most-models-p-374.html

Jan 20, 2011 | Philips 7140XL Electric Shaver

1 Answer

My razor appears to have died even though the LED


Usually the batteries last only a few years before needing replacement. Rechargeable batteries are good for only so many cycles so you've done well to go 8 years. You can replace the batteries if you're handy with a soldering iron - I've done it many times. However, with 8 years on the clock you'll probably want to replace the blades too. The batteries are about $10 for the pair (AA rechargeables with solder tabs) and the blade set is about $30 so you're approaching the cost of a new shaver already. Here's a link - you'll need two.
http://www.zbattery.com/NiCad-AA-1000mAh-Rechargeable-Battery-with-Solder-Tabs

Apr 18, 2010 | Norelco SmartTouch 9160XL Electric Shaver

1 Answer

Norelco Quadra Action 7866XL suddenly quit working any ideas


It sounds like the rechargeable batteries in your shaver have degraded to the point that they can no longer be recharged, and as such, you shaver won't run, even with the power cord connected and plugged in.

To get the shaver working like new again, you need to replace the batteries or have it done for you. If you have the tools to desolder and resolder the rechargeable batteries, and can disassemble the shaver, you could do this yourself. However, most people find that having the shaver serviced for them is preferrable, since there could be a chance of damaging the shaver when taking it apart, etc.

If you wish to get an estimate for having the batteries replaced for you, contact www.electricshaver.com or you can call them at 1-888-476-1785

They are an authorized service and repair center for most major brands of electric shavers and typically get the repairs done in about a week, once they receive the shaver. They also sell most common replacement cutter blocks and foil screens for shavers, in case you need new ones now or in the future.

I hope you find this Very Helpful and best regards!

Nov 12, 2009 | Norelco Quadra 7866 XL Electric Shaver

1 Answer

Rechargeable Shaver will not turn on even when connected to A/C.


Jessy, Your rechargeable battery has finally degraded to the point that it is no longer capable of being recharged. Also, once rechargeable batteries get to a certain point, as yours have, the use of the power cord won't allow the shaver to operate either, since the battery can't pass the electric current through them to the motor, etc.

The good news is that for a few dollars, you can have your electric shaver working like new again. The batteries are replaceable, but you'll have to either disassemble it yourself, or have this done by a qualified service center, as it requires the ability to de-solder and re-solder it onto the motor circuit board.

If you want to have it done (or do it yourself), you can contact www.electricshaver.com or call them at 1-888-476-1785 and request a quote for having the service done by them, or ask them to verify the correct replacement batteries for your Norelco shaver. Typically, the proper battery for the Norelco 7710 shaver is part number 13810584. This is a Nickel Metal Hydride (Ni Mh) Rechargeable 1.2V with solder tabs, AA size.
You'll find that for a very low cost repair, you can extend the working life of your rechargeable shaver by many more years. I've done this many times myself and find I've saved literally hundreds of dollars, especially given the rather high cost of new electric shavers today.

I hope you find this Very Helpful and best regards!

Nov 01, 2009 | Norelco Shavers

2 Answers

Braun 5750 needs new battery -this i think is only available with circuit board - where can i purchase or get this shaver repaired


If you are handy and know how to solder (and have the tools required), you can probably do the replacement yourself.

At the bottom of the razor are two plastic caps on either side of the charging port, you'll need to pry them out with a sharp pick or thin knive tip. Once removed, you can get to the screws that hold the front and rear case halfs onto the main shaver chassis where the PCB with the rechargeable battery is soldered onto the board.

Unsolder the battery and solder in the new replacement battery and put the case back together, making sure all the parts are in the correct posistion, and you're ready to recharge the shaver and start shaving again. If you're going to replace the internal board, it's just a matter of simply replacing the entire board and orienting the motor assembly connection onto the new PCB.

To find your replacement parts or batteries, try Electric Shaver Service. They also do repairs, so you might want to get an estimate if you don't want to do the repair yourself, etc. They're reliable and fast in getting shavers repaired and back to you quickly. 1-888-476-1785

Here's a link to the page with your battery on it and the toll free number to call for estimates too.

www.electricshaver.com

Hope you find this Very Helpful and best regards!

Oct 12, 2009 | Braun Shavers

1 Answer

I want to replace rechargable batt. in Braun mod. 5569u. Unsure how to access without destroying housing


Kurt, If you are handy and can dissemble and solder, you can do this yourself, otherwise, you can send it off to a repair service that will do this for you.

If you wish to do this yourself, you'll have to take the shaver apart. There are two (2) small plastic caps on the bottom of the shaver that can be removed with a small pick or flatbladed screwdriver. Once those are out, you can unscrew the two screws that hold the shaver together and gently pry off the side panels. They have to be slid slightly down to release them from the main housing frame.

This will expose the internal circuit board and the rechargable batteries that need to be unsolded. You can then reinstall NEW rechargable batteries and solder them onto the PCB (printed circuit board). You can also purchase a complete internal PCB with the batteries and everything you need, you just swap out the electronics for the new one, although this costs about $39, while the batteries alone are much less.

Put the shell together and reinstall the retaining screws and caps and you're done. Let the shaver get a full charge before you start using it again, and it might take a couple of use and discharge cycles before the batteries will be able to take an optimal charge.

Here's a link to get the replacement batteries for your shaver. They also do the repair service, if you don't want to do it yourself.

http://www.electricshaverstore.com/search.asp?p=1&w=%5F&c=battery&t=s

Hope you find this Very Helpful and best regards!

Sep 24, 2009 | Braun Shavers

2 Answers

Braun electric shaver will not charge.


Your batteries are no longer capable of being recharged and need to be replaced.

If you are handy and can dissemble and solder, you can do this yourself, otherwise, you can send it off to a repair service that will do this for you.

If you wish to do this yourself, you'll have to take the shaver apart. There are two (2) small plastic caps on the bottom of the shaver that can be removed with a small pick or flatbladed screwdriver. Once those are out, you can unscrew the two screws that hold the shaver together and gently pry off the side panels.

This will expose the internal circuit board and the rechargable batteries that need to be unsolded. You can then reinstall NEW rechargable batteries and solder them onto the PCB (printed circuit board). You can also purchase a complete internal PCB with the batteries and everything you need, you just swap out the electronics for the new one, although this costs about $39, while the batteries alone are much less.

Put the shell together and reinstall the retaining screws and caps and you're done.

Here's a link to get the replacement batteries for your shaver. They also do the repair service, if you don't want to do it yourself.

http://www.electricshaverstore.com/search.asp?p=1&w=%5F&c=battery&t=s

Hope you find this Very Helpful and best regards!

Sep 05, 2009 | Braun Flex Integral Shaver 5520

2 Answers

Battery won't hold its charge, could I get them replaced? Could I replace them myself? If so, with what type of battery?


Rechargeable shavers use either a NiCad or NiMd batteries.

In order to get the correct battery, you need to check your shaver model number and check the following link to see which your shaver uses.

http://www.electricshaverstore.com/search.asp?p=1&w=%5F&c=battery&t=s

You can buy it from them or find them elsewhere, if you wish.

You can do the repair yourself if you can disassemble the shaver case, which is usually held together with a couple of screws normally hidden behind plastic caps.

Then once the shaver covers are off, you can unsolder the old batteries and replace and resolder the new one in. You'll need a decent soldering iron to accomplish this.

When done, put the case back together and allow it to charge for a good 8 hours before using. It typically takes a few recharges to get the batteries able to hold a full charge, but you should be good after a week of use.

Hope you find this Very Helpful and best regards!

Aug 23, 2009 | Remington Shavers

Not finding what you are looking for?
Panasonic ER 240 Beard Trimmer Logo

Related Topics:

1,090 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Shavers Experts

shaveroutlet.com
shaveroutlet.com

Level 3 Expert

1544 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Rick Goldsmith
Rick Goldsmith

Level 1 Expert

15 Answers

Are you a Panasonic Shaver Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...