I am looking for a repair manual for okifax 700 fax machine. Specifically looking for the page that talks about the technician setup options

The baud rate is automatically set by the machine when it connects to the remote machine. The machines start at the highest speed and drop down until both machines can send/receive without any errors then they send the pages. You can not manually set the speed.

Buddymc

clean led head with alcohol pad! located underside of drum unit door! May need to replace transfer roller(black roller under drum)hope this helps!

How do you get a confirmtion page after faxing on a Canon 3235i imagerunneer

Fax machine just possibly needs a good cleaning.

You can change the Transmit Resolution but not the resolution or the quality of the faxes received.

If your machine makes goog copies and prints, the problem is on the sender's side.

This is an excerpt from the troubleshooting section of your machine manual:

The image received on your fax machine was very poor. Contact the person sending you the fax and ask them to change their Transmit Resolution and Type of Original settings. Ask the person to make a copy of the document on their fax machine to ensure that it is working properly. Then ask them to send the fax again. If you still have a problem, try making a copy of a document on your machine to make sure it is working properly

enter a blank page and press button of copy.

Try the following with the machine in standby mode. (no document fed)
Press MENU/EXIT key ONCE.
Press RESOLUTION key TWICE.
LCD display should indicate "Technical Prg."
Press DOWN ARROW key ONCE
LCD -display should indicate "2 Setup"
Press RIGHT ARROW key ONCE
LCD display should indicate "Setup"
Press the DOWN ARROW key TWELVE times.
LCD display should indicate "13>H/Modem Rate"
Press the RIGHT ARROW key ONCE.
*** NOTE WHAT IT IS ALREADY & DO NOT FORGET IT IN CASE YOU WANT TO UNDO ***
Press the DOWN ARROW key repeatedly to change the setting to 4.8, 9.6, 14.4, 28.8 or 33.6K.
For "9400" set it to "9.6" (9.6K = 9600 Baud)

Also note that for this to fix your problems I would expect to find your machine is currently set to 14.4 or higher.
Change it and see how it works for you. If it is no good, you can always change it back to the original setting.

Do you have an analog phone line or are you trying to run it through a PBX system? I was just having this discussion with RKS tech support. Their fax software was hanging up as soon as the connection was established and all I had available was a VOIP phone line. It took 4 tries but I found a US Robotics fax/modem that worked fine in class 2.0 mode.

you can download a copy of the manual from the OKI website:
http://www.oki.co.uk/binaryData/2299/2600uGB.pdf