Had to push green reset button on 1/3 hp garage master motor

Your logic board is bad.

The old remotes are a different frequency and will not work.

If the wall button will operate the door up but none of the devices do then look at the wall button. Find the lock button and push it for 2 seconds and then try the remotes again. This is your vacation lock. You can get a manual at chamberlain.com. Now if the door does not open or close with the remotes you can reprogram them. Press the colored learn button on the motor head and then press the button on the remote. Repeat for each remote. If they fail to program you will need a new logic board. Thanks BB

If you are trying to reset the code for the keypad, locate the smart/learn button on the rear of the motor unit. Press and immediately release this button and then walk over to the keypad and key in any 4 digit code you like and press enter.

If you are trying to reset the code for the hand remotes, you can't.

Most likely your door sensors are out of alignment. Make sure they are pointed directly at one another.

To erase the memory of the opener so that your old remote will no longer work you need to locate the smart/learn button on the rear of the motor unit. Press and hold this button for 6 seconds. No remotes will now work.

To program the new remote when you get it, hold the button down on the remote and then press and immediately release the smart/learn button.

Call any local door opener repair company from the yellow pages and you should be able to buy a remote from them.

push the green button on the opener then push your remote button

Remove the cover and take a look at the drive gear. It is white nylon and is just in front of the motor. It is probably stripped. It is a good time to release the door from the opener and try raising it by hand. Your door springs may be weak or possibly broken.

You don't need to reprogram. You need to make sure your door sensors haven't been bumped and misaligned. Each of them has a small light that will be lit when they are properly aligned. Tweak them a bit. If the light doesn't come on you probably have a sensor that has quit working.

How does everything look well? How old is unit? Did you push learn button for 10 seconds. Then pusj for 1 second and activate a remote button. lightbulb on motor should blink. if so, hit learn again for 1 second and push button on other remote. Do you have a LOCK or VACATION button. Make sure it is off . Is light on wall console blinking. you have remotes locked out.