Question about West Bend The Co W.Bend Timer Dual Timer

2 Answers

My husband bought me a West bend timer and now I can't set the clock! Can you help? He isn't any help, lol.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Press and hold the clock button for a few seconds, then use the hour, minute, and second buttons to set the clock.

Posted on Nov 16, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,734 Answers

Ask here, the can get you virtually any West Bend manual.

Posted on Jul 23, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Cannot set the atomic clock

The Atomic Clock is automatic. It consists of a radio signal which is broadcast from Colorado once or twice a day, and which will reach around the world. If you think your clock is not set, place it on a west-facing windowsill, and leave it there for a day or so. Sounds like magic, but that's how it works. I have three "atomic" clocks, and they all reset automatically. As a matter of fact, they all reset to Standard Time this past weekend.Good Luck!

Nov 05, 2012 | Timers

1 Answer

Timer rotates but whenever it reaches the tripper to turn the lights on it gets stuck there. It's like there isn't enough power to rotat the switch to turn the lights on. Have checked the switch...

The clock motor gets weak and sticks on the tripper and then stops working.
Possible solution: Some people report they disassembled clock motor, cleaned the gears and added a bit of vaseline or white grease to gears because they get dirty.
Then afterward, you might try duct tape to seal unit from dust
Others report they got the clock motor apart and didn't mark parts and take photos along the way, and forgot how tiny gears went back.
My experience with clock motors, and motors in general, is when they slow down, they overheat and don't last much longer.
There are no replacement clock motors for ML series power packs, which is shortcoming since Intermatic makes replacement clock motors and modules for many of their products.

Work-around: Set timer to override, then plug power pack into cheap wall timer.

Jun 26, 2011 | Intermatic Malibu 300W Power Pack...

1 Answer

How do I set the time on a Sunbeam kitchen timer

Without it having an actual clock function, this is impossible. However, if you wish to set a countdown timer, I suggest you turn the knob clockwise to the desired amount of time to which you need to be notified then sit and wait for the "ding".... LoL! Great question!

Jul 29, 2010 | Sunbeam Timer

1 Answer

Was hiding the evidence that I bought a new transformer, threw box & directions away! Need help in setting the clock, lights keep coming on at 4 in afternoon, would be ok in Alaska but i live in...

Sounds like a stupid answer, but make sure the timer wheel is rotated to the correct time. Also, make sure the on/off trip pins are set to the correct times. It is common for the time to be off if you ever lose power.

Jul 02, 2010 | Intermatic & Malibu& 300 Watt Power/Pack...

1 Answer

Timer stopped running so I replace timer motor. However the timer still does not run. I can still turn pool pump on manually. Will I have to replace entire unit?

T103 clock motor is 125 volt WG1570
1) If you bought the 240V WG1573, the clock will not operate
2) If you connected the motor wires to wrong terminals, then clock will not operate.
3) If original box label says T103, but 240V T104 was installed in same box, and you bought wrong voltage motor
4) Test for 120Volts across terminals A and 1, and make sure clock motor matches voltage of timer, and clock motor wires are connected to terminals A and 1.
Open following links:

Jun 26, 2010 | Intermatic T103 Indoor 120-Volt 40-amp...

Not finding what you are looking for?
West Bend The  Co W.Bend Timer Dual Timer Logo

Related Topics:

263 people viewed this question

Ask a Question

Usually answered in minutes!

Top West Bend Timers Experts

Jay Finke
Jay Finke

Level 3 Expert

1222 Answers


Level 3 Expert

3287 Answers


Level 2 Expert

90 Answers

Are you a West Bend Timer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides