Question about Sony XM-D6000GTX Car Audio Amplifier

1 Answer

No sound no light...nothing

I was driving and I turned the volume up a little bit and my sub just went out. I pulled over to take a look at it and the light on the sub amp was out. I noticed that a soda had spilled on my other amp but that one was working fine. Its a sony xplod im not sure what the wattage is it is pretty big. I'm using monstor cables and its just a 10" jl sub. What do u think the problem is? I have no clue

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 113 Answers
Re: no sound no light...nothing - Sony XM-D6000GTX Car Audio Amplifier Car Amplifiers

Check all power present first

Posted on Aug 09, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

When i turn my alpine MRP-M650 amp on there is a click in the sub and then nothing else. when i was driving with volume down low the sub just stopped working.

sounds like a short. did you check the amp fuse and the fuse on the power wire (under the hood) make sure there are no wires touching. most common is the wires to the sub touching on the amp. let me knwo if that helped

May 17, 2011 | Alpine MRP-M650 Car Audio Amplifier

1 Answer

Sub not working

there might be transistors that went bad

May 01, 2010 | Kicker 06ZX750.1 Car Audio Amplifier

1 Answer

Subs have almost no sound coming from them

Hello meow_mix_666,

If you have tried different amps and different subs with the same result, I'd definitely suspect that you are not getting enough of an output signal from the head unit. Checking the RCA's and perhaps using a different set of preamp outs would be a good idea.

One other possibility that you may not have considered is to check the phasing. I've run into speakers that had the markings reversed and running the subs out-of-phase on a 4-channel bridged would make a huge difference in the bass.

Hope this helps.

May 10, 2009 | Alpine MRP-F300 Car Audio Amplifier

1 Answer

Amp keeps kicking off

hey unplug your amps and waiting 15 minutes and plug them in...the amp went to protect mode to keep it from blowing...should work unless you have a amp that only the factory can reboot but most amps just reset themselves if you do what i just told you

Apr 06, 2009 | Eclipse (EA2000) Car Audio Amplifier

1 Answer

Amp green then red light then nothing problem please help

It sounds like the output transistors have failed. To eliminate other possible problems, read through the following page.

Troubleshooting - Amp in Protect Mode

Let me know if you have any other questions.

Aug 05, 2008 | SPL Dynamics Z2X-1600 Car Audio Amplifier

1 Answer

Not working

maybe you should use 4 awg wire

Jun 24, 2008 | Rockford Fosgate Punch P5002 Car Audio...

2 Answers

Sony Xplod 500w green power light no sound

try running the system with a cross-over configuration.

So your left + will be left + and your right + will be in the right + but put the right (-) where the left (-) is and left (-) where the right (-) is. If that doesnt work, then that means that you shorted out your audio out channels. the only way you can fix that is if you have good soldering skills. But other than that I'de say scrap it, unless you have the high outputs and then buy another amp, some mids and highs and connect the mids and highs to the xplod

Feb 23, 2008 | Sony Xplod XM-1652Z Car Audio Amplifier

1 Answer

Flashing Protect light

what are u using to play music??

Feb 12, 2008 | Infinity Reference 5350a Car Audio...

1 Answer

Alpine mrp-m650 amp cutting out

Some AMPs have a thermal cutout, that switches the amp off if it gets too HOT.

But this sounds like your amp or sub is screwed, either there is to much resistance in your sub, eg: Burnt voice coil, carbon builds up on the coil stopping the sub from moving freely. Push on the cone of the sub & listen for a scrapeing sound.
or test this by continuity testing the sub terminals & pushing the cone if the BUZZER on the MultiMeter cuts in & out as you push & release then your sub is screwed. ( a certain amount of repeatative pushing it may free up the voice coil.)

or your Amp may have blown a internal fault that will have to be sent of for repair.

Or you have a incorrectly rated fuse for your system,

or the battery cant kope with the power surges???

Dec 19, 2007 | Alpine MRP-M650 Car Audio Amplifier

1 Answer

Rockford Fosgate P3002 Amp

what are the color of the lights that stay protect/ green=on.if the amp has little sound it probably still working,check deck output volume(rca)

Aug 22, 2007 | Sony Xplod XM-554ZR Car Audio Amplifier

Not finding what you are looking for?
Sony XM-D6000GTX Car Audio Amplifier Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Car Amplifiers Experts

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers


Level 3 Expert

56798 Answers

Are you a Sony Car Amplifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides