Hi everybody,when i on the camera it comes ABORT!

Hi,

Please try below link

Panasonice SDR-H40

It could be the heater element, if the wash water does not reach the temp selected by you within a certain time period, the w/m could abort the cycle.
The pump or outlet hoses could be blocked and the w/m cannot expel the waste water between rinses.( This would be if the machine stops and is still full of water). Try running a cold wash cycle and this should confirm if it is the element as it will complete the cycle ok.
Hope this help

If your camera is getting hot when you turn it on, then YOU HAVE A SHORT CIRCUIT in your camera electronic component(s) that causing the camera to become hot (rather unusual condition if you can feel it heating up!...): if it is just over 12 months, try to get it repaired under warranty... you can only ask!

Hope it clarifies the situation.

I use w210 Sony Cybershot! I was taking pictures out in the sun, when I saw smoke coming out the camera and the camera become very hot. I also saw that I was using the camera bymistakely in the twilight mode out in the sun. And since then I tried intitializing it but the Error E:91:01 and flash symbol wont stop blinking. And flash Seems to have stopped working. Please help me to solve this problem

Bangalore
Seshan Cameras
1017, 2nd Floor, Dr. Raj Kumar Road,
Rajaji Nagar, Bangalore-560 010
Tel: 3385465
Chennai
Shetala Cameras
F46, 1st Floor Spencer Plaza-Phase ll
969 Anna Salai.
Chennai-600 002
Tel: 91-8410699
Hyderabad
Shetala Cameras
Shop No: 2, 1st Floor,
No: 5-8-809/112 Orient Estate Abids,
Hyderabad-1
Tel: 3243356

Download the most recent version of Zoom Browser from Canon.

In photo editing programs there are Hue settings where you can easily fix that problem. There are off course night lens filters but not for amateur cameras.

sir u contact ur near service center this is simple problum just clean ur camera CCD

same thing here

This appears to be loose connector to the motherboatd from the screen.
Try gentle squeezing of the casing near the bottom of the body
This may do the trick- otheriwise it is a workshop job and frankly not worth the cost - the money would be better spent on a more uptodate camera.