Will not complete spin cycle - Maytag Washing Machines

Sure sounds like your timer has bit the dust. I'm not sure if the timer is still available. You have a great washer there. Good luck.

If the individual part/function CAN work, but it wont complete a cycle, suspect the control board...

Washer Repair - Not Advancing -Repair & Diagnostic ...

? 8:30
https://www.youtube.com/watch?v=IEr9A7uhdN8
Sep 6, 2013 - Uploaded by ApplianceVideo.com
Repair your Kenmore Top Load Washer suffering from these following issues: Will Not Advance Past Rinse ...

Kenmore washer doesn't complete final spin cycle - ApplianceBlog

www.applianceblog.com/.../31894-Kenmore-washer-doesn-t-complete-fi...
May 16, 2012 - 9 posts - ‎2 authors hello, my kenmore washer doesn't complete the final spin cycle. i ... Does it stop in the middle of the final spin cycle or does it not go into the ... FIXED Kenmore Washer - Not finishing the spin cycle
9 posts
Dec 20, 2014
FIXED Washing Machine Does Not Complete Cycle ...
10 posts
Mar 14, 2013
FIXED Kenmore washer won't spin out all water from ...
10 posts
Jun 27, 2009
FIXED GE front load washer WCVH6260F0WW stops ...
10 posts
Jul 2, 2007
More results from www.applianceblog.com

Pcboard mulfunctioning

Broken or has come off. Drive belt

No erro codes to the console correct?

If so see if the machine will complete a Spin Only cycle with no clothes in the wash basket. Set the Spin setting to Spin/Hang dry seting and start the cycle. It should take about 10 min complete. Does the Spin Only cycle complete with no clothes in the wash basket?

Some handy links if you are going to DIY.........Service Manual

Hello, when the clothes are partly wet when cycle is complete then check these.
1. Motor coupler
2. Spin cycle

MOTOR COUPLER; To test the motor coupler, restart the washer in it's spin cycle,let the machine runs for a minutes and then open the lid and notice if the tub is spinning: if it's spinning when you lift the lid that means the coupler is fine and if it doesn't spin that means you have to replace it.
SPIN CYCLE: If the washer doesn't reach it's proper spin speed,the cloth may be wet at the end of the cycle,check to be if the load is properly balanced and run a spin cycle again,if the clothes are still wet, you may have a worn or loose belt which you have to replace.
Thanks

need make & model # to correctly solve problem, it could be timer shorted or the drive motor has gone bad.

OK, what you are experiencing is a timer mechanism fault. the timer motor is malfunctioning. anytime you have to manually advance the timer knob, this will signal a fault within the control mech. this is easily fixed by, replacing the timer control module. i will place a link to the actual part needed to fix this issue. you can also purchase this timer on line at this site if you wish.

CLICK HERE