Question about Sony FD Trinitron WEGA KV-34HS420 34" TV

1 Answer

TV switch light flickers 11 times but no function

Sony Trinitron Colour TV Model No. KV-24LS35U
The picture collapsed to a vertical line while the TV was showing and then turned to a black screen. The Starting-Switch-Light started to flicker periodically (10 flickers of red/green at about one second intervals followed by a green light for about 3 seconds and this event repeting itself at intervals of about 13 seconds). When the television is switched off and then on again the same event repeats itself at the same intervals.
Please advise me what may be the cause of this problem and suggessted remedies for it.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 272 Answers

Hopefully it is only a board component that needs replacing and your dry joints that need re-doing. I would advise that you take it to a television repair shop as this type of repair can be very complex (replacing resistors and capacitors just to name a few).

Posted on Dec 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why are green horizontal lines are appearing, too much yellow colour and green light blinking red?


These horizontal lines are vertical flyback lines and would indicate
one or more of the tubes cathode drive circuits are defective.
As the picture is predominantly yellow this would indicate excessive drive to red and green guns. Check the red and green video output stages especialy any clamping diodes.regards from Vintie

Sep 19, 2013 | Sony FD Trinitron WEGA KV-21CL10 21" TV

1 Answer

Sony FD Trinitron WEGA Tv - LAMP blinking 11 times


Sony tv has self protection program. The red Led blinking light indicate the probable cause location. For this model it is either 2,4 or 5 flashes every 3 second. Please check the blinking again

Feb 09, 2010 | Sony FD Trinitron WEGA KV-27FS120 27" TV

1 Answer

Black screen model kv-27fs200 there is sound just no picture stand by light blinks 4 times the pauses and does it again


4 times standby light blink shows problem in vertical deflection section of TV.
Please check and replace vertical output IC in main board.
Thanks.

Dec 27, 2009 | Sony FD Trinitron WEGA KV-27FS200 27" TV

3 Answers

Kv-32fs16, no picture or sound , red lights flash 4 times


Hi
In sony tv`s the 4 blink code(sony error codes)usually means that there is a vertical deflection problem.
It is often caused by a faulty vertical output i.c and/or related components. If you feel handy with a soldering iron let me know and i`ll help you with it.
Hope this help Merry Christmas

Dec 17, 2009 | Sony FD Trinitron WEGA KV-32FS120 32" TV

1 Answer

Sony Trinitron Colour TV Stopped showing and switch light flicker


The vertical output IC has failed/Power to the vertical IC is out/ or there is bad solder on the pins of the vertical output IC.

Dec 01, 2008 | Sony FD Trinitron WEGA KV-34HS420 34" TV

1 Answer

Tv turning off


Hello
Sony FD Triniton Wega KV-36XBR400 service manual has no info for 11 times flash. It has info up to 7 falshes. Please count again. Error codes are in below pictures...

0000abe.jpg a288bbc.jpg
Regards,

Aug 27, 2008 | Sony FD Trinitron WEGA KV-32XBR400 32" TV

1 Answer

Sony KV-24LS35U green light flashing 11 times


The Sony error codes go up to 7, so when the standby light flashes 11 times it usually means that one of the clock or data lines deep inside the set is shorted to ground. This is not fixable from the front or through the remote, so the set should be serviced by a qualified tech familiar with Sony sets.

Aug 06, 2007 | Sony KV-DR29M69 29" TV

1 Answer

Sony Trinitron kv32fs16 picture shrinks


You have a bad solder connection in the vertical circuit. This will require you to resolder these bad connections before it blows out the vertical output IC or other parts in the circuit. Do this ASAP before you make a small repair into a large one. If you have no solid state printed circuit board experience, please play it safe and take the set into a pro to do this for you. Good Luck

Jun 28, 2007 | Sony FD Trinitron WEGA KV-29LS35 29" TV

Not finding what you are looking for?
Sony FD Trinitron WEGA KV-34HS420 34" TV Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68157 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Are you a Sony Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...