Question about Whirlpool ER6AHKXPQ Top Freezer Refrigerator

3 Answers

My inbuilt Whirlpool APM 6528 fridge keeps alarming

A while back, the red 'alarm' light lit along with 3 and 7 temeprature buttons both flashing together. This flashing was also accompanied by a rather annoying 'beep'. Looking in the manual, it recommends I contact Whirlpool and arrange a service engineer, although it does also say the temperature will remain ok. Whilst not ideal, I lived with it for a month or so, but this annoying beep, drove me up the wall. So, I decided to act on this and set about removing the beeper from the circuit board. Removal of the panel from the inside of the fridge was easy and I soon had the beeper off and silecnced forever !!!!!! Since silencing of the beeper, the fridge now seems to be very cold even though the temperature is set to 7 degrees. And the flashing error code remains. . . . Any ideas as to what I can do to fix this thing ? How can removal of a beeper cause the temperture to drop ?
Cheers

Posted by on

  • 1 more comment 
  • Anonymous Mar 24, 2009

    APM 6528 fridge keeps alarming.




  • Trevor Haw Apr 09, 2009

    Same problem. Defrosted fridge, switched off for an hour, removed cooler box, tried everything in the book.



    Trevor

  • Trevor Haw Apr 09, 2009

    Defrosted the fridge, switched off for an hour, removed the cooler box, tried everything in the book, same problem.



    cheers Trev

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Your appliance is short of refrigerant

Posted on Jan 21, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Same thing happen to mine. Tried the defrost method but did not work. Called out a service engineer who replaced the thermostat worked for about one year then same thing again. Still beeping so gave up with this fridge. Looking at a different fridge to replace this one.

Posted on Aug 08, 2010

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have had similar problems with the electronic control module. Replacing the whole module would cost about £160. I have repaired mine by bypassing the electronic controls. The fridge compressor is controlled by a 12 volt relay on the circuit board. I have wired the relay to an extenal frost thermostat (Sunvic TLX9401, £12.50 from toolstation.com) and it now works OK.
Philip Shields

Posted on Jun 13, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I fix the continuous beeping coming from my refrigerator?


LG Fridge Door Alarm ' Chris Inch

www.chrisinch.com/blog/articles/show/lg-fridge-door-alarm/
Aug 30, 2006 - It's just too bad I can't live with beeping noises going off every 30 seconds. .... took them a long time and they scratched the paint) the fridge beganbeeping ..... I opened the fridge door to let the alarm sound and then located the alarm..... I can't tell you how many times I've "snapped" since hearing this thing.

FIXED Frigidaire Professional Constant Beeping - ApplianceBlog

www.applianceblog.com/.../17546-Frigidaire-Professional-Constant-Bee...

Jan 15, 2010 - 10 posts - ‎3 authors
The refrigerator is not refrigerating and I don't here the fan go on or ... the water comes out from the water dispenser and so does the ice. ... Thank You so much! ... The unit is two years old from time of purchase. ... Then to install it you remove the #81 screws here: 11-Controls parts .... All times are GMT -6.

Fisher & Paykel fridge in alarm - Kitchen - Home - Whirlpool

forums.whirlpool.net.au > Home > Kitchen

WhirlpoolJan 24, 2010 - I push the selector button to mute the alarm and then it may not do it again ... I can determine the fault code through the number of beeps/flashes? ... myfridge started beeping every 6 hours abut a week ago. ... posted 2012-Aug-7, 3:17 pm.... If so, defrost the coils behind freezer, you can use a hair dryer to ...

Feb 03, 2016 | Refrigerators

5 Answers

Security light flashes and it won't start


top
CODE ALARM SYSTEM
information is always subject to change and correction Used on:
Impreza 1996-2001
Legacy 1995-1999
Forester 1998-2000
codealarmremote2.jpgBattery GP-23A
Lock: Left button will lock all doors. Double chirp indicates locked.
Unlock: Right button will unlock driver's door only. Hold unlock button app 6 seconds, it will unlock all doors including rear gate. Single chirp indicated unlock.
If the car chirps or lights flash 4x the alarm was triggered.
Panic. Press both buttons to activate emergency honk and flashing lights.
Valet mode: With optional alarm only Press the red alarm button on the left of the steering wheel. The light will quickly double flash. To re-set back to normal mode, press the red alarm light button again

Battery failed and lights flashing?
Parking lights will flash when the vehicle's battery is disconnected and reconnected.
To stop lights from flashing, either:
Press remote transmitter “UNLOCK” button once OR turn the ignition switch to the “ON” position and press programming button for one second (see below).
The vehicle interior (courtesy) light and door open warning light (DOOR AJAR indicator) will then illuminate for 60 seconds when the ignition is turned off, or until the doors are locked with the remote transmitter. Yes, the dashboard instrument panel lights will flash when the parking lights flash.
Programming or Overriding the Alarm when you have lost the remote
Open driver's door.
Turn ignition key to 'On'
Press and *hold programming button* in (see diagram, button under dashboard)
After 15 seconds the the door locks will cycle 3 times. Do not release Programming button
Press lock (left) button the remotes to be programmed. The door locks will cycle one time.
Exit programming mode by releasing Programming button under dashboard and turning key to off.

codealarmremote1.jpgCode Alarm Programming Button is under dashboard on the kick panel by the driver's left knee, left of the steering column. If you can't find it, it might still be tucked up in the wiring harness higher up in that same general area. The botton is recessed in a plastic ring (see diagram).
This button must be pressed while programming remotes or if the battery was disconnected and the lights are flashing.
top

Jul 10, 2008 | 1996 Subaru Legacy

1 Answer

Cricut mini flashing red light


1-Open Cricut Craft Room with circuit on and flashing green/red
2-Hold power & feed button together until both are solid green
3-You'll be prompted to update firmware
4-Press & hold two buttons again (keep holding)
5-initiate firmware update
6-Let sequence go until 99% ...you may hear a sequence of beeping, don't be alarmed
7-Release buttons
8-You'll be prompted to restart your machine
9-Unplug all plugs from Cricut
10-Wait 30 seconds
11-Plug in both cords
12-Power on Cricut
13-Light should be solid green
14-Press OK on Craftroom prompt on computer
15-Done

Jan 03, 2014 | Provo Craft Cricut Disney Font Cartridge

2 Answers

My double door firge frezeer is not icing and the red alarm button is alarming all the time


Glori,
you mite need to replace your thermostat,...... the alarm button is
telling u that your fridge is not cold enough, there is also probably another prob but u need to b a electrician to sort it on the top of fridge there is a panel,.. under that there is a fusible link if one blows it will need to b replaced its soldered in no job for u unless ur a electrician hope this helps

Oct 24, 2013 | Red Defy Helmet Youth 2012

1 Answer

How can you set the Caixing CX-2158 to 12 hr time instead of the military time?


for clock settings

Clock buttons from the left.

[1] Set
[2] Shift
[3] Modify
[4] Alarm
[5] End
[6] Reset - (use paperclip to push button in hole.)


Light indicators

[A] A.M.
[C] P.M.
[B] Alarm(s) active.
[D] Hour Notice

To set time and date

1.Push SET, push SHIFT to transfer from YEAR to MONTH to DAY to HOUR to MINUTE
2. Push MODIFY to change to desired value in every field (blinking)
3. Press SET or END to save.

To change from 24 - 12 hour format
1. Press MODIFY continously for about 3 to 5 seconds
NOTE: in 24-hour format, both the A.M and P.M light is OFF


TO SET ALARM

1. Push ALARM, and alarm setting number 1 will show, push ALARM again to show alarms up to 8 or 9 (depending on model)
2. When desired alarm number is chosen, Press SET
3. Push SHIFT to transfer from HOUR to MINUTE
4. Push MODIFY to change desired value in every field( blinking)
5. Push END to save, (Please note Red ALARM light will lit)


TO CANCEL ALARM

1. Push ALARM until the desired alarm to cancel is shown.
2. Press MODIFY ( the dispaly will show --:--)
3. Press END (NOTE: Alarm light would only turn off only if all alarm is cancelled)

TO SET HOURLY NOTIFICATION OFF AND ON

1. Push MODIFY button once (hour notice light would lit) - hourly notice is turned ON
2. Push MODIFY button again (hour notice light is off) - hourly notice is OFF

Oct 01, 2011 | Vacuums

1 Answer

Red light flashing when power button pushed


how many red lights are flashing is their 4 lights all corners lit up or is it 3 red lights with 1 corner not lit up, let me know then i can assist you further

Dec 07, 2010 | Microsoft Xbox 360 Console

2 Answers

Theres a ring around the disc


the ring is from the console being moved when the system was on you can resurface the disk or theres a disk replacement program but with that ring it most likely will not work

Nov 29, 2010 | Microsoft Xbox 360 Console

1 Answer

I just changed the starter, disconnected battery


Under dash by your left knee is a 4"x4" box. It has a small wire lead with a button on the end. Turn ignition on and push button. Resets the alarm. THis will stop your lights from flashing. Have a great day.

Sep 25, 2009 | 1998 Subaru Legacy

Not finding what you are looking for?
Whirlpool ER6AHKXPQ Top Freezer Refrigerator Logo

1,262 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Refrigerators Experts

John Tripp
John Tripp

Level 3 Expert

4654 Answers

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Steve

Level 3 Expert

3287 Answers

Are you a Whirlpool Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...