Question about Rockford Fosgate 25 To LIFE Punch 150 2-Channel Amp - 150W 25 To LIFE Series ¿ 180W Bridged Mono ¿ R... Car Audio Amplifier

1 Answer

How much would installing a headunit, amp, and subs usually cost?

I own a Buick LeSabre limited 2000 and have 2 10" rockford fosgate punch subs and a 150 watt rockford fosgate punch amp, with a pioneer head unit and i havee everything i just need it installed.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 4 Answers

Hows it going so you need it to be installed or you can install this yourself? well the best bet fund to get stuff done cheap is t get the stuf you will need to do an install like a install wiring kit and tools and post a installer help on craigslist.org iin your local area would be the cheapest way or just go to your local audio stereo shop thanks again and i hoope this help have any more questions please feel free to contact me if you need a step by step install i can help you in that and save you big bucks thanks again. always forward jcbproducts

Posted on Dec 03, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Bridging two12" subs and one 15" sub to my Rockford fosgate T 1500bd amp


assuming all 3 subs are 3-4 ohms, running all 3 in parallel (the 3 positive leads all attach to the amp positive terminal, and all 3 speaker negative leads connect to the amp negative terminal) will bring you at or above 1 ohm, which the amp is capable of handling. With 1500 watts, you will want to use 8 gague power leads for the amp, 12 gague speaker cables, and an inline 120 amp fuse between the amp and the battery, within 1 foot of the battery.

Jan 11, 2017 | Rockford Fosgate Car Audio & Video

1 Answer

I need operator's manual / instructions for Sony CDX-GT11W


The operating instructions and installation guide for the CDW-GT11W are available from the manufacturer's support site: https://esupport.sony.com/US/p/model-home.pl?mdl=CDXGT11W&template_id=1®ion_id=1&tab=manuals#/manualsTab . Click on the Manuals, Specs & Warranty tab. I needed to refresh the next page to download the manual (click on the circle with the arrow going clockwise). The direct link to the manual is currently https://docs.sony.com/release//CDXGT11W.pdf .

I hope this helps.

Cindy Wells

Jan 09, 2017 | Sony Car Audio & Video

1 Answer

I need to replace my model #SF002. Where in Rockford, Il is it available? It is well over 10 years old.


Would need more details like what this is and what brand. You posted this question in car audio

Jan 09, 2017 | Car Audio & Video

2 Answers

I have a Sony STR-KM7 AMP and the subwoofers have stopped working?


Sorry but it sounds like the subwoofer voice coil has shorted, you will need to replace the sub.

Jan 08, 2017 | Sony Car Audio & Video

1 Answer

So how do wire this set set up to a bridged amp any help would be appreciated


assuming that is a dvc dual 4 ohm speaker, and you have a 2 ohm bridged amp, you run a positive from each side of the speaker into the bridged positive of the power amp, and run a negative from each side of the speaker into the negative bridged terminal of the amp. if, indeed, you have 2 4 ohm voice coils, running them bridged in parallel wiring will bring the load to 2 ohms. if you have 4 voice coils, of 4 ohms apiece, you could run all 4 parallel into the amp, but that would bring the load down to 1 ohm, and you would have to make sure you8r amp can support 1 ohm operation.

Jan 07, 2017 | Car Audio & Video

1 Answer

I have a boss 400w riot 2-4 channels,how do i connect the high level wires? Because stereo doesn't have rca's


to use the high level leads, you have to isolate the wires going to each speaker (if using 4 channel mode) or isolate the wires going just to the rear if you are using 2 channel mode. you have to strip a small piece of the insulation off each speaker wire, and run it into the amps high level input harness. if you dont have the high level input harness, you can get a 2 channel high level to rca adapter for around $20. basically, you are tapping into the signal to the stock speakers to feed music to the amp. make sure you get all your positives and negatives correct. brighter wires are usually positive; however you may be faced with sa speaker which uses a grey wire, and another grey wire- the second with a black line. you will have to, again, turn to internet research to determine which is positive and negative, if the colors are not obvious.

Dec 30, 2016 | Boss Car Audio & Video

1 Answer

Sirpintine belt routing


Before you take the belt off draw yourself a picture of the pulleys position and draw around the pulleys how they go on. I find that works. my car I can get my small camera low enough to take a picture.

Aug 27, 2016 | Jeep 2007 Grand Cherokee Limited 4WD

1 Answer

Usb


You need a new USB cable the new Kenwood and pioneer headunits have to have there own USB cable, go to you local audio dealer or go online and get a pioneer USB cable, they run $24 , I got my Kenwood one and they just have the option of total control from the headunit or not

Nov 16, 2012 | Car Audio & Video

2 Answers

No power to amp


check and try finding another grounding spot

May 16, 2010 | Lightning Audio B4.250.2 Car Amp

Not finding what you are looking for?
Car Audio & Video Logo

383 people viewed this question

Ask a Question

Usually answered in minutes!

Top Rockford Fosgate Car Audio & Video Experts

Pablo Gonzalez

Level 3 Expert

733 Answers

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Professor_V
Professor_V

Level 2 Expert

92 Answers

Are you a Rockford Fosgate Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...