Question about Smith & Wesson Sport & Outdoor

1 Answer

Can'treassemble 30-30 marlin

I completely disassembled a 30-30 marlin and now i am not figure out how to put it back together, and help would be greatly appreciated

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 55 Answers

Http://www.marlinfirearms.com/pdfs/manuals/MFC_Centerfire.pdf

this is the link to the manual for the marlin 30-30. It's pretty detailed

Good luck
Rob

Posted on Dec 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a Smith and Wesson model 36 five shot


Hope you did not loose any parts. Take it apart again or take it to a gun smith. I would take it apart again first. you might also want to sweep the area with a magnet like the ones from the builder supply store, before you vacuum. you might just find a missing clip, spring or pin.

Oct 09, 2014 | Sport & Outdoor

1 Answer

My MSR Pocket Rocket will no longer light. Prior to the complete malfunction, the flame started to become much weaker, and then finally, the burner just would not light. I've removed the rubber o-ring on...


Hi, chances are the jet is clogged - I've experienced this myself on the same stove.

I would leave the rubber o ring alone, the chances of the hole there being blocked are slim, it is more likely to be the outlet jet you can see throught the holes on the riser tube under the burner head.
This tube can be unscrewed - you may need to put something through like a pen for leverage. Once you have done this you can remove the tube and you will see the tiny jet in the top of the brass nut on the knurled base of the stove. Then its simply a matter of finding a thin enough wire or pricker to prod araound in the jet. I have a fine wire brush that works well, although I have only had to do it once in several years.
Put it all back together and you should be back to full power - the whole job takes two minutes tops.
The other thing I did was screw the riser tube back hand tight only - this means I can dismantle and clear the jet when camping if required. It doesnt affect performance or safety. I put a strand of the wire in a blob of blu tak in the plastic case the stove comes with - job done! Hope this helps.

May 03, 2011 | MSR Pocket Rocket Stove

1 Answer

How do i put back together my paintball gun? it is a game face bone daddy BL


Cant tell you how to put it back together but next time layout the pieces as you take it apart left to right so you can remember how to put it back together again

Mar 28, 2010 | Tippmann A 5 Standard Paintball Gun

3 Answers

I need help reassembling my Crosman 1088....I had to take it apart for repair now im having trouble figuring out how the hammer mechanism goes back together correctly....I have the exploded view and parts...


Well.. it's really rather late, so I don't know if you're still trying to put the thing back together, but I was just having issues getting the hammer assembly on mine to work..

Going from this parts list: http://www.shans2003.ru/Article/pi_Crosman_1088-EVP.pdf

Assuming you had the same problem I did:
Start by putting the trigger assembly in (parts 37 and 40, the shorter pin on 40 goes through the holes on 37 as shown in the diagram)
Then insert pin 28 in to the hole that's right at the crook where your thumb rests.
Then part 35 goes over that pin with the little tiny nub pointing towards the back of the gun.
Spring 36 goes over that nub, and slides against the flat spot in the frame.

Pin 27 will then be placed in to the hole just above the hole for pin 28.
Then slide the hammer over said pin. now comes the tricky part. You will need something of moderate length, extremely thin and decently strong, I used an exacto knife. Use your tool of choice to press part 35 back, compressing the spring and push the hammer against the frame.

The two pins on the hammer should be in position such that the hook on the trigger assembly, and the crook on part 35 rest against them.

Once you have that done, keep holding the hammer in place, hook the spring hanging from it over the pin set in the frame. (should be pretty clear which one. and then re-assemble the rest of the gun.

Be warned spring 29 does not like going back in. you will likely feel like you need 3 hands (one for the hammer, one for assembly 60/spring 29 and one to put the frame back on.

Hope it helps.

Nov 10, 2009 | Sport & Outdoor

2 Answers

We need instructions for a Thermos pop up tent. we bought at a yardsale with no instructs.


Is it the tent with the plastic staves? If so, just put them together and insert the rounded end into the equivalent hole on the bottom of the tent. Sit the tent upright with the doors open. Reach into the top of the tent and push/pull the chrome lever at the top until it locks into position. Sometimes you have to wiggle it around a little to get it to lock. When it does lock, you will know it because the tent is rigid. This is a great tent. We have used one for over 40 years! When you want to disassemble it, just pull down on the chrome lever at the top of the tent and reverse the procedure.

Oct 12, 2009 | Sport & Outdoor

1 Answer

Seals are weak.


Yes! Carefully note disassembly to help putting it back together! Download manual here:
http://www.crosman.com/airguns/service/manuals/crosman-rifles

Nov 27, 2008 | Sport & Outdoor

1 Answer

2004 KAWASAKI KXF250


try a new plug sometimes a plug will not fire under compression. also adj the valves

Nov 25, 2008 | kawasaki Full Suspension Mountain Bike Men

Not finding what you are looking for?
Sport & Outdoor Logo

Related Topics:

363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Smith & Wesson Sport & Outdoor Experts

yadayada
yadayada

Level 3 Expert

60659 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3051 Answers

kakima

Level 3 Expert

96362 Answers

Are you a Smith & Wesson Sport and Outdoor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...