Question about McCulloch 13HP 338 Cc Portable Generator # FG6000MK

1 Answer

Won't start. I have a never used McCulloch 5700 11HP Power Generator. I purchased maybe 2 years ago never turn it on, just sat in garage. I'm trying to get it started. Nothing. Please advise. Thank you.

Posted by on

  • 1 more comment 
  • raw28 Dec 02, 2008

    I will attempt this process. Thanks for reply.

  • budvtwin Dec 20, 2008

    I have exactly the same situation as this with my 5700 watt 11 HP McCullough generator. I'm getting good gas to the plug but no spark. I have lost my manual and don't know how to obtain a new one. Any help?

  • Frank
    Frank May 11, 2010

    it is self contain cross between an over size lawn mower and a mini car. check the battery first. use fresh gas. make sure the spark plug is good and tight. press the button and go.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 185 Answers

Hi raw 28:

ther gas that was in the carb probably evaporated. you might tryt a little spray starter fluid in the spark plug hole or in the air intake of the carb, This might just get it running long enough to draw gas into the carb and get it self sustaining,

Good luck Loringh

Posted on Dec 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Has gas in bowl and fire but wont start without starting fluid


McCulloch u spray starter fluid Power Generators Questions ...

www.fixya.com > Forum > Tags > u spray starter fluid > Power Generators
McCulloch power generators u spray starter fluid related questions and ... Question about 13HP 338 Cc Portable Generator # FG6000MK ... My 5700 watt 11 HPMcCullough generator wont ... My generator will start if I spray it with either but won'tstay running in less I keep ... The bowl has gas in it and the needle is clean.

This generator McCulloch fg6000mk 11hp has no spark. I've ...

www.fixya.com/.../t7785814-generator_mcculloch_fg6000mk_11hp_no
Jan 13, 2011 - this generator McCulloch fg6000mk 11hp has no spark. I've checked the gas bowl , a small amount of water in the - McCulloch ... water in the bowl not much also sprayed a small amount of starting fluid in .... My 5700 watt 11 HPMcCullough generator wont start. I'm getting good gas to the plug but no spark.

Won't start. I have a never used McCulloch 5700 11HP ...

www.dqrkc.com/support/t1325485-start
Dec 2, 2008 - Question about McCulloch 13HP 338 Cc Portable Generator # ...evaporated. you might tryt a little spray starter fluid in the spark plug ... My generatorwill start if I spray it with either but won't stay running in ... The bowl has gas in it and the needle is clean. ... My 5700 watt 11 HP McCullough generator wont.

1325485 Won't start. I have a never used McCulloch 5700


Jan 21, 2016 | McCulloch 11 HP 5700 WATT GENERATOR

1 Answer

My Makita G5500r power generator doesn't have smooth Idle?


sounds like the carb needs to be cleaned inside any fuel the was left in the carb goes bad and it never runs it all out

Sep 06, 2012 | Power Generators

1 Answer

My generator will not start


I bet the spark plug has water on it's gap. Take it out to clean and dry. I bet it will start then. Robert

May 11, 2012 | McCulloch 6.5 HP 3500W GENERATOR

1 Answer

I have an ACDELCO 6500 Watt Electric Start Generator. i bought it brand new about 1 year ago and it started up with no problems. Unfortunately I did not drain the gas after using it and it sat idle with...


Fuel will go stale if left for a long time. Drain and clean fuel tank and also drop float bowl on carburettor to remove any old fuel. If there is any sediment in the float bowl a carby clean could also be necessary.

Aug 24, 2010 | BUFFALO ACDelco 6500 Watt Generator...

1 Answer

McCulloch Generator model FG6000mk 11hp run good until I turn on generator then stop running do you think the generator bad and can it be rebuild ?


I did not understand how you turn on generator, as it is always turned on.
If you use the ON/OFF switch it is stopping the prime mover.
If you reset the AC breaker without load, and it stops - it means that you have short circuit after the breaker. Check the output receptacles.
Try this link:
http://weborder.husqvarna.com/order_static/doc/MOUS/MOUS2008/MOUS2008-FG6000MK-7096FG6024-966991401.pdf 

Jun 12, 2010 | McCulloch 13HP 338 Cc Portable Generator #...

1 Answer

Coleman powermate 3750 watt brand new I started it


Check the oil level & try again to start many times until it became loose because the engine became stock up for long time not use.

Mar 12, 2009 | Coleman Powermate Powermate 5000W...

1 Answer

Coleman 6200 won't work


Hi Judy,
Generators DO last a good long time for the money, but they have to be both used and maintained in order to keep working properly. What has most likely happened is that you didn't use the generator at all for a year, after it sat on your dealers shelf for a few months not being used, and so the tiny bit of magnetism it uses to "kickstart" the process of making electricity has worn down. The good news is that this is easy for a generator shop to repair, no parts involved and the minimum labor that they charge. They need to do something called flashing the field of the generator. What they can't do is get Coleman to pay for it since they aren't around anymore, go ahead try the 800 number (waits patiently).

Be nice to the poor generator techs at the shop.

Nov 24, 2008 | Coleman Powermate Premium Plus 6250W...

3 Answers

Just won't start


check the spark plug after a failed attempt to start. If dry, then no fuel is entering engine.
Did you leave old fuel in carb? if so, your carb probably is dirty: old gasoline deposits varnish, gum, and you will need to dissassemble carb and clean it.

Nov 14, 2008 | McCulloch 13HP 338 Cc Portable Generator #...

1 Answer

Generator will not generate electricity.


I assume it is a hand start genset. The most common problem if it has been sat for a while is rust on the ignition timing flywheel. If you take the pullcord housing off (recoil) then you will see a big flywheel with what can only be described as a big forked prong with a couple of wires on it. This flywheel should be stainless steel and rusts when sat around for a while without use. Its job is to complete the circuit to the spark plug every time the flywheel passes the forked prong at a given spot on the flywheel, the faster the wheel turns the faster the spark hence the engine runs quicker. Clean the rust off with a releasing agent (wd 40) hey presto!!!!!!!!!!!

Sep 17, 2008 | McCulloch 13HP 338 Cc Portable Generator #...

Not finding what you are looking for?
McCulloch 13HP 338 Cc Portable Generator # FG6000MK Logo

544 people viewed this question

Ask a Question

Usually answered in minutes!

Top McCulloch Power Generators Experts

John Trevino

Level 3 Expert

1378 Answers

EugenesDIYDen
EugenesDIYDen

Level 3 Expert

479 Answers

Roland W VanLue
Roland W VanLue

Level 3 Expert

375 Answers

Are you a McCulloch Power Generator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...