1984 Camaro Z28 Wiper switch wont work properly

mine was both a bad wiper switch and wiper motor.
when my dash lights acted up, a new HL switch sorted me out fine.

check for power both sides of fues and then at switch,most switches in steering colum have relays some switches make contact with earth so no power goes to then they just make the earth circet for the relay ie relay has power all the time when it is earthed the switch in the relay turn on and power to the wiper motor,but first check for power and earth at the wiper motor if you haven't already,that should have been before replacing motor

Hello,

Please follow the steps below to remove or replace the wiper arm:

1. With the hood closed, turn the wipers on, when the wipers are in the middle of their arc turn the key to the off position. (Note: if this can't be done because of wiper condition and you want to avoid scratching the windshield please open your hood to gain access)
2. Locate the mounting clips at the top pivot on the wiper blade
3. Release the clip and remove the wiper arm
4. Match the size of the old blade against the new blade to ensure proper fit and operation
5. Reinstall the new wiper blade and recheck wiper operation

Hope this helped. Thank You for using FixYa!!!

i dont remember exactly on camaros, but if you dont see a nut on the wiper arm, then there is a plastic cap covering it. remove that with a screwdriver by prying off gently. and loosen the nut almost all the way off. now wiggle the wiper arm back and forth and up and down.. you might need a screw driver to pry from underneath with slight force. wiper arms are tricky. make sure you put it in the exact position you took it off from. sometimes you have to turn the wipers on and shut off the key to stop them if the hood is in the way,

pick blade up and press the pins togethor and pull out and slide the new ones in recommend the rain x blades work really good

the relay is built into the wiper motor its called the pulse contol module and comes with a new wiper motor. make the wipers come on and then get them to stay on while wiper switch is in the off position, then tap the wiper motor and see if it turns off, if it does then u need a wiper motor assembly and be careful opening the hood some wiper arms will contact the hood when the hood is open and the wipers are on

did you install them in the off position. this will affect where they stop

go to any parts store and buy the blades they will change them fro free, and watch while they are doing it.

float arm in the tank is either stuck or broken. its connected to the fuel pump assembly

i want to ask is there is any possebl to jump the starter and run the car without using the ignition switch ?