Replace the motor, the run winding is shot.It is not hard to replace the motor. The blower has reverse threads(righty loosy). The motor has a quick connect(no wiring needed). Yank out the filter first.Remove the 2 screws in the filter
housing on top.Then use a putty knife to pop the top. Remove the screws
holding the front panel on. VERY IMPORTANT! Raise the front up an inch
before pulling forward or the panel clips will break! Some models have
a panel on bottom. If they do then this panel must come off first. Then
you remove the door springs and back off the screws holding down the
bottom of the door panel. Then pop the top and remove the screws on top
to get the panel out of your way.Get the idler loose and remove the drum. Clean it all up and replace the motor. I can do it in 20 minutes. It is simple and uncomplicated. Go for it.
If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61
98 views
Usually answered in minutes!
×