- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
When you click Print then right click on your HP ptinter - click Properties - Paper Quality tab - click Paper source and select Tray 2 - Click OK - then OK to print. You can change the paper type in Tray 2 into Tray 1 and vice versa to save going into Properties to change the Tray selection.
Remove the all orange tape from the outside of the printer.
Remove orange tape from paper tray 2.
Remove the orange packing tape from inside paper tray 3.
Remove the spacer from inside the print cartridge area.
Load all paper trays.
Pull the paper trays completely out of the printer.
Press the blue tab on the rear paper length guide and adjust the rear guide so that the pointer matches the size of the paper to be loaded.
Move the side width guides outward to match the desired paper size.
Add the media to the paper trays, make sure that it is flat in the tray at all four corners. Keep the media below the height tabs on the sides and rear of the tray. Push down on the metal lift plate to lock it in place.
Slide the trays back into the printer.
Install the print cartridge.
Remove the print cartridge from the packaging.
Rock the print cartridge back and forth several times to "mix" the toner.
Pull the sealing tape from the end of the print cartridge to remove the entire length of the tape.
Open the top cover.
Slide the print cartridge into the unit.
Close the print cartridge door.
Connect the LAN cable (optional). (HP LaserJet 2420n, 2420dn, 2430tn, and 2430dtn models only)
Please print a configuration page from the control panel of the printer
- Menu > Information menu > print configuration.
- Check for paper handling details.
Following setting should reflect.
Tray 1: Any size / Any Type
Tray 2: A4 size / Plain Type
If the above settings are not reflecting in the configuration page, please change accordingly by browsing on the control panel of the printer to:
Paper Handling Menu >
Tray 1 Size: Any
Tray 1 Type: Any
Tray 2 Size: A4
Tray 2 Type: Plain