Question about Power Acoustik GOTHIC OV2-520 Car Audio Amplifier

1 Answer

Power Acoustik I am trying to install a power acoustik gothic amp and the red light on the amp is on. When I touch the ground wire to the amp the red light goes off but nothing happens. I am not sure what the problem is. I have tried to find a manual online but no luck. Any help would be appreciated.

Posted by on

  • Anonymous Mar 18, 2014

    Can I strap a3500d Gothic to a 6000d gothic

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

The amp shouldnt even lite up w/o the ground attached.

Posted on Dec 30, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power Acoustik amp


First thing to do is check the fuse. If it is still in good condition then you may have blown your amp

You can make sure no wires are touching an also tried wiring in a mode that does not put it at its maximum ohm load.

Dec 14, 2014 | Audio Players & Recorders

1 Answer

I have a power acoustik 0v2-300 2 channel amp i just wanna know can i bridge it


Most amps will show right on the amp by the speaker wire terminals if it is bridgeable.
Good luck !

Jan 28, 2010 | Power Acoustik GOTHIC OV2-300 Car Audio...

1 Answer

How to bridge a 4ch power acoustik amp to 2ch


I had the Power acoustik saphire 4ch and had to do the same thing. Use the Positive from Term1 (spkr1) and Negative from Term2(spkr2). Good Luck.

Nov 26, 2009 | Power Acoustik GOTHIC OV4-800 Car Audio...

1 Answer

Power acoustik gothic OV2 800 manual


Could not get a manual for you but did get the follwing specs. Hope they help.

Power Acoustik Ov2-800 2-Channel Class A/B Gothic Series Amplifier (800-Watt)
POWER ACOUSTIK OV2-800 2-CHANNEL CLASS A/B GOTHIC SERIES AMPLIFIER

800-WATT 2-CHANNEL
4 ohm RMS: 150W X 2
2 ohm RMS: 180W X 2
Bridged mode MONO RMS: 360W
BRIDGED MAX: 800W
FULL MOSFET POWER SUPPLY
PWM CIRCUITRY
FULL SELECTABLE CROSSOVER
3-WAY PROTECTION CIRCUIT
TRI-MODE CAPABLE
VARIABLE LOW PASS 40 HZ - 120 HZ
VARIABLE HIGH PASS 150 HZ - 1.5 KHZ
VARIABLE 18 DB BASS BOOST @ 40 HZ
FREQ RESP: 10 HZ TO 30 KHZ
S/N RATIO: 98 DB
THD: 0.02%
2 ohm STABLE STEREO
SYSTEM DISTRESS INDICATOR
HIGH/LOW LEVEL INPUTS WITH FLOATING GROUND
4-GAUGE POWER/GROUND CONNECTION
PLATINUM RCA CONNECTORS
LINE OUTPUT WITH FLOATING GROUND

BLUE LED
CHROME TOP PLATE PANEL 2-CHANNEL CLASS A/B GOTHIC SERIES AMPLIFIER (800-WATT)

Aug 18, 2009 | Power Acoustik GOTHIC OV2-800 Car Audio...

1 Answer

Amp is not putting out, shuts down


you have a bad ground recheck your ground and make sure you have a good one
or the guage of your power wire isnt big enough

May 01, 2009 | Power Acoustik GOTHIC OV2-1800 Car Amp

2 Answers

Amp keeps blowin the two 30amp fuses on the amp.


Make sure that the speaker wires are wired correct at both the amp and the speakers......otherwise it sounds like the typical death of a power acoustik amp (great amps, but prone to a premature death)

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_aad3edb7dfa380b9

Mar 29, 2009 | Power Acoustik GOTHIC OV2-1200 Car Audio...

2 Answers

Amp light is neither green or red


have u connectted the remote wire from head unit to turn amp on? have u got + and - the rite way round.hope this of use.

Mar 05, 2009 | Power Acoustik PS2-1250 Car Audio...

1 Answer

My amp goes in protect mode


Maybe the audio amplifier IC´s are damaged

Feb 06, 2009 | Power Acoustik GOTHIC OV2-1200 Car Audio...

1 Answer

Power Acoustik G320-2 Gothic Series


If you're geting no lights on the amp, you need to confirm that you have voltage at the amp. If you haven't done so yet, check the on-board fuses.

With your multimeter set to DC volts, the black meter lead on the ground terminal of the amp (not on the point where the ground wire connected to the vehicle) and the head unit on (so the amp will have remote voltage applied), touch the red lead alternately to the B+ and remote terminals of the amp. If the voltage is below ~11 volts, you need to check the wiring feeding whichever line is too low.

May 09, 2008 | Car Audio & Video

Not finding what you are looking for?
Power Acoustik GOTHIC OV2-520 Car Audio Amplifier Logo

Related Topics:

240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Power Acoustik Car Audio & Video Experts

yadayada
yadayada

Level 3 Expert

80531 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17130 Answers

The Knight
The Knight

Level 3 Expert

75581 Answers

Are you a Power Acoustik Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...