Question about Polaroid PDV-0701A Portable DVD Player

1 Answer

Unit is dead

My unit wont turn on, no lights or anything. I think the syscon circuit is damaged.

Posted by on

  • sunsetmaiden Feb 21, 2008

    My unit was accidentally dropped. However, my problem is similar to the first one: the player won't turn on, it's as if there is no power to it at all. I've checked the things that were suggested in the last post, but to no avail. Is there even any hope for this product?



    Thanks...

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 790 Answers

All you have to do is to check the charging pin,charging terminal,and charging circuit.check all fusibul resistors!!! around the said section.

Posted on Sep 09, 2007

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Samsung home theatre trips off the whole light in the house when plugged in and the lights comes back on when unplugged. What ic is responsible for this pls ?


Unless your house circuits are incorrectly wired, the lights shouldn't go out. Lighting, heating and power outlets should be on separate circuits and individual circuits for stoves, dryers and water heaters. Also separate circuits for each floor too.

Anyway an IC (integrated circuit - a 'chip') wouldn't cause this. You have a dead short in the power supply unit which takes the mains voltage and reduces it to the voltage that the unit uses, probably 5 or 12 volts.

Did you check the cord to see if it has been damaged? Sometimes, cats, dogs, mice, or continual bending or kinking can cause the insulation to fail and when the wires touch, you have your dead short.

Jun 07, 2016 | Samsung Audio Players & Recorders

1 Answer

Why is my pride pursuit scooter dead... no lights anything


Sounds like the water has damaged the controller or the wiring.

Oct 19, 2014 | Pride Pursuit Xl Heavy Duty 4-wheel...

1 Answer

Did I short out my kenwood in-car stereo?


To be honest if you have taken it apart then it is fried and the circuit board is not easy to replace i recommend a new radio, next time run your usb wire loose as you can so it wont never snag

May 29, 2013 | Kenwood Car Audio & Video

1 Answer

Panasonic SA-PT860 standby light on but wont turn on?


Check and replace the damaged component/s at its audio output stage circuit. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/
Circuit diagrams of many popular brand TVs and other devices are given.

May 20, 2012 | Panasonic Audio Players & Recorders

3 Answers

Wont charge or turn on


not sure how long you have had this, but if the unit was completely turned off or battery completely dead, you have to hold the power button for about 15 seconds for the 3000t to start up...assuming the charge light at the top right is orange (that means its charging) no light means its not charging, green light means fully charged. if there is no power light on at the top right of unit, either the charger is bad or the port on the board is bad (which i do have) good luck and hope this helps. bill

Jul 05, 2009 | Magellan RoadMate 3000T GPS Receiver

1 Answer

Sanyo EM-710F display dead


Low voltage Tx actually OK. Restored vaporised circuit tracks on controller board, fuse and interior light globe. All working OK.

Jun 18, 2008 | Microwave Ovens

1 Answer

Problem


If the AC power source (outlet) is ok and the line cord and fuse are ok but the unit is completely dead, you may have a problem with the internal switching power supply.

Locate the switching power supply and see if there is a fuse on its circuit board.

Completely dead units are typically caused by a failure in the power supply section.

Please let me know if I can be of further assistance to you.

Good luck!

- Jim

Mar 06, 2008 | Sony SLV-D360P DVD Player/VCR

3 Answers

Maytag microwave - mod# mmv5100aaw


CHECK MAGNETRON RELATED CIRCUIT, HIGH VOLTAGE CIRCUIT, CONTROL CIRCUIT,AFTER CHECK MAINS FUSE.

Aug 29, 2007 | Maytag MMV1153A Microwave Oven

1 Answer

Dropped the unit, doesn't fully power on now


You would first have to open up the unit and look carefully and see what is maybe broken or out of place. Look for loose connections. Check damaged parts.

Aug 15, 2006 | Xact Communication XTR7CK SIRIUS Radio...

Not finding what you are looking for?
Polaroid PDV-0701A Portable DVD Player Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Polaroid Televison & Video Experts

The Knight
The Knight

Level 3 Expert

75157 Answers

matt martin
matt martin

Level 3 Expert

1213 Answers

Jaime Hernandez

Level 3 Expert

2334 Answers

Are you a Polaroid Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...