Question about Zanussi TC7102W Electric Dryer

1 Answer

Zannusi TCE7127W Not turning if load too heavy

Recently our 2year old Zabussie condensor TCE7127W has started to stop the programme that is selected through a failure to start turning the drum. We can get it to work once me remove some "threshold" portion of the load. It should run with 6kg's of clothes and has never had a problem with large loads before.

Is it a motor problem?
Is it something else?
Can I DIY fix it/investigate it as it is out of warranty?

Any ideas appreciated

Posted by on

  • tom1cameron Dec 01, 2008

    Wow, thanks for this.

    The condensor is the thing that cools the water, the capacitator sounds like something to do with power.



    Is there a way to test this solution by testing the old part somehow?



    Thanks

  • tom1cameron Feb 19, 2009

    Big thankyou, just pulled it out and got no sparks at the shorting procedure and certainly no charge or tingling when I picked it up! I'll order a new one.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 249 Answers

It is very likely to be the condensur,or it is called a capacitor ,device for storing electric charge to boost the starting of the motor under load.in other words change it.UF will be wrote on it maybe 10 uf .I feel wasted on this site its so easy .

Posted on Nov 30, 2008

  • eamonn close Dec 01, 2008

    You would buy for about $10=€7 ,but anyway put a live and neg across the two spades connections on the capacitor 220 V.ac current ,you would have to remove it from the dryer ,one nut,then disconnect it from the current ,and cross the two connections on the capacitor if the capacitor gives off a good spark its OK if it thos not it is f**ked

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dryer is growling when spinning heavy loads.


The bearings may be gone, but I don't know how old your machine is or the brand. If it is over 8 years old, consider replacing it. Maybe get an estimate from a repairman who knows your brand.

Jun 09, 2015 | Dryers

1 Answer

My AEG T37400 lavatherm standanlone tumble dryer works for a turns of the drum then stops.


Alarm conditions during operation of the dryer

The LEDs begin to flash if one of the following malfunctions occurs:
  • NTC open (the LEDs flash in sequence from right to left)
  • NTC short-circuited (the LEDs flash in sequence from right to left)
  • If the START button is pressed for more than 20 seconds while a cycle is in operation all the LEDs flash.
25679338-hf2jxxovvq5cn05mugly0fcq-5-5.jpg If the microprocessor identifies one of the conditions listed above, operation of the dryer is interrupted; the LEDs continue to flash in order to warn the user of the malfunction.
If the error is eliminated, the dryer returns to normal operation when the programme selector knob is turned to RESET and the drying cycle is re-selected.

Dado

May 04, 2015 | AEG Dryers

1 Answer

Zanussi TCE 7276W Condensor Dryer - no red lights but won't go!


Hello, have you cleaned the condensor stack just recently if so check that the stack etc is fitted correctly and the door is closed fully.

Hope this helps.

May 14, 2010 | Dryers

1 Answer

Zanussi TCE 7276W Condensor Dryer - no red lights but won't go!


Hello,
Has the condenser been cleaned lately if it is not put back in correctly then sometimes the micro switch on the door does not click in,check this door where the condenser sits.

Hope this helps.

Mar 25, 2010 | Dryers

1 Answer

We have a very old Kenmore Heavy Duty 80 series washer and dryer. I have a 2 part question. 1.our dryer recently began stopping after a minute or so after turning it on. When you push the start button, it...


That growl is the motor bearing. The replacement is not difficult. The blower is reversed threads. I have repair photos HERE

The washer is an 18 pound (dry weight) capacity

Feb 15, 2010 | Dryers

1 Answer

LG TROMM Front Load Dryer / Not drying clothes


check the vent or condensor depending on what type of dryer.

Sep 28, 2009 | Dryers

1 Answer

Zanussi TCE7127W - Exhaust air is damp?


Check the exhaust hose for blockage. They normaly need to be cleaned out periodicly
.The exhaust hose is how it gets rid of moisture.

Nov 12, 2008 | Zanussi TC7102W Electric Dryer

Not finding what you are looking for?
Zanussi TC7102W Electric Dryer Logo

Related Topics:

179 people viewed this question

Ask a Question

Usually answered in minutes!

Top Zanussi Dryers Experts

Tim Whalen

Level 3 Expert

3056 Answers

yadayada
yadayada

Level 3 Expert

61129 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Zanussi Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...