Question about Candy CN126 Front Load Washer

1 Answer

Buttons on CE124 candy eclypsa not working

My washing machine has been fine but suddenly after loading it the on/off button wouldnt push in & the open button doesnt do anything.could this be the lock mechanism gone and if so is this an expensive job? Any advice appreciated!

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 66 Answers
Re: Buttons on CE124 candy eclypsa not working

The on/off switch sounds faulty they can get hot and jam, with the button stuck in you cant open the door, the switch will have to be replaced

Posted on Jun 25, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

My washing machine motor not rotating in washing cycle. Motor works well in Spinning cycles, but not working agitatewashing movement in any cycle. It's water filling, stopping and draining all works

Would help to have the model and type...but typically if the tub is not agitating the coupling between the motor and the tub is worn out or broken. However, if it is spinning properly, it probably indicates a problem with the transmission. Really need to know what type of washer it is to help pin down the problem. Any "burnt" smells coming from the washer? Give a little more information and maybe we can figure it out. Top load...side load, make and model preferred. You can locate that information on a plate usually attached inside the door on most models.

Apr 17, 2016 | Candy Washing Machines

1 Answer

How do in remove the control panel on my candy washing machine to fix buttons that have been pushed in too far?

Remove the top cover of the washer. look in there, remove the screw of each end of the panel.look into the back of it u see a plastic stopper at each side left and right,push it by finger.pull the panel backward .

Sep 08, 2015 | Candy Washing Machines

1 Answer

Candy Washing machine control buttons pushed in and stuck in

you need to take top panel off and replace the inner push buttons

Jan 31, 2015 | Candy Washing Machines

1 Answer

Candy eclypsa ce104

it will need replacing the valve is at the top right on the rear

Jan 12, 2014 | Candy Washing Machines

1 Answer

I think I have a coin between inner and outer drum CE124. Do I need to remove it or just put up with it clanking on spin?

I would not try to remove it if I were you,, best to leave it alone as it should eventually find it's way into the pump filter.

Nov 22, 2010 | Candy CNW136 Front Load Washer/Dryer

1 Answer

Candy Eclypsa CE124/1 drum does not move on any cycle, even spin cycle.

It sounds like the motor brushes have failed. Quite a common fault and not too complicated to fix.

Oct 25, 2010 | Washing Machines

1 Answer

Candy CE124 washing machine

tricity bendix washing machine will not complete cycle aw1201, its starts the cycle then goes straight to the end

Jun 29, 2008 | Washing Machines

1 Answer

CNW136 Dryer not working !!

lift the lid with the power off and reset the safety stat. look for a and little red button on the metal heater duct on the top of the machine

Jan 08, 2008 | Candy CNW136 Front Load Washer/Dryer

Not finding what you are looking for?
Candy CN126 Front Load Washer Logo

875 people viewed this question

Ask a Question

Usually answered in minutes!

Top Candy Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1456 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers


Level 3 Expert

57192 Answers

Are you a Candy Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides