Question about Projection Televisions

4 Answers

Goodmans headphone PRD CD 9007 SRD-S1 1996-I-GB. The service Phone number on the set is un-obtainable. I require to be able to use two sets of headphones from the same TV. Can this be done using the existing base?

Posted by on

  • 1 more comment 
  • swarewolf Nov 29, 2008

    Space is a problem, I would prefer just to run two sets of headphones from the one control, rather than have two completely different sets from one outlet.

  • swarewolf Nov 29, 2008

    Can I just use a headset without an additional base unit?

  • swarewolf Dec 04, 2008

    There are two control buttons on the left earpiece. priodically there is sound distortion whoch can ba rectified temporarily by pressing one of the bittons but this does not prevent it happening again, sometimes several times.

×

4 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Projection T... Master
  • 13,433 Answers

You can use a spliter that turns one output into two so you could connect two sets of headphones into the tv, I don't know if two headphones can be used with the same base, which company where you trying to reach`?

Posted on Nov 29, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,427 Answers

Yes you can use one base for multiple head sets ,, the auto tuning function will automatically detect the base's frequency and will connect.

Posted on Nov 29, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 6,966 Answers

Hi and welcome to FixYa,

Offhand I would venture a yes. One of the features of this unit is "Auto scan for RF tuning" meaning the headset will lock on to the signal of the base. Although I am not sure if you can purchase just the headset alone.

Just a start, do postback how things turned up or should you need additional information. Good luck and Thank you for using FixYa.

Posted on Nov 29, 2008

  • Louie  Role
    Louie Role Dec 04, 2008

    Hi again,



    Any updates or developments so far?





×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 849 Answers

Yaeh, you can, get a stereo spliter from electronics market. it will devide one audio output to two audio stereo outputs.

Posted on Nov 29, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Changed bulb on my sony srd projection tv but still won't come on


Look first to make sure lamp was installed correctly---which light on front of set blinks---look for it to blink in a sequence of say 5 then pause and repeat--a error code is indicated.

Nov 06, 2012 | Projection Televisions

3 Answers

Panasonic th42px25 require a digital tuner replacement, how to do it?


Try Here to get digital tuner for your Panasonic plasma TV.
Hope they will help you out.

Aug 09, 2008 | Panasonic Projection Televisions

2 Answers

Goodmans VHS 6 head/didgital stereo GVR5020NVP serial No. 015653332 require a remote control and instruction book. wish to link up with digital tv


May i know the model and the make of the product in details so that it can help me resolving the issue is a more prompt manner

May 01, 2008 | Projection Televisions

1 Answer

Sony srd shut off


Double check to make completely sure the lamp went in perfectly--even experts sometimes do not get it in correctly---also if set not coming on what lights are blinking on front---the red one should blink a specific number of times indication of error code.

Apr 22, 2012 | Sony KDS-R50XBR1 50" HDTV

1 Answer

Consistant green blinking light


Hello, i will list the criteria required to service TV and projector TV`s first and foremost you require a good understanding of how TV`s work and the ability of reading schematic diagrams, then you require a knowledge of how printed circuit boards are patterned so you can navigate around them to locate possible trouble spots.
then you require
1 multi meter of good quality
1 oscilloscope 20 MHz or better
1 shop service manual pertinent to your type and model of unit you wish to repair
this is a minimum requirement of test equipment you can have

you also kneed a location or locations to obtain the replacement parts you may require to complete the service task.
Now if you have all the above criteria in place then you have some hope to service your unit

a flashing red indicator on your TV usually refers to an internal circuit failure, most modern TV`s have circuits incorporated in the circuit design to protect good working components not involved in the fault from further damage so the set will not power up and an indicator light will start flashing, trouble spots can be anything like power supply under voltage, over voltage over current, no vertical deflection, excessive high voltage, XRAY, convergence failure,, EXT EXT,EXT,
Warning rear projection televisions can harbor in excess of 30,000 ,yes that is thousand Volts

There are and never will be user serviceable components inside LOL

Now if you are ready and require further assistance you may contact me and i will step you through the diagnostic procedures Good luck

Mar 01, 2011 | Mitsubishi WS-48513 48" Rear Projection...

1 Answer

No longer seems to get any ppower to turn on it was working before it went into the moving van


hi, would help immensely if we knew who built the set and the model number. obviously the move has either un-plugged a connector somewhere inside the set or the move has broken a few solder joints, remove the back cover and with the set un-plugged check for a good connection on all the cables, you`ll have to take boards out to check solder, gl, video-tek

May 31, 2009 | Philips Projection Televisions

1 Answer

WANT TO LOCATE TABLE TOP STAND, CURRENTLY WALL MOUNTED


yes we have stock of most tv stands many makes in stock goodmans, techwood, murphy,LG, Sony, Technosonic etc prices from £15.00 call for details 07979438800 please leave message if unanswered many thanks

Apr 13, 2009 | Projection Televisions

1 Answer

Color is mostly yellow and blue with double images


you have lost the convergence IC`s in your set, this really isn`t a diy repair unless you are very proficient in un-soldering and re-soldering components, once replaced there will be an alignment procedure as well that will require the service manual also, if you have more questions feel free to ask away, video-tek

Feb 04, 2009 | Hitachi 53UDX10B 53" Rear Projection...

1 Answer

I own a goodmans gtv26wlcd and have recently had the problem with the screen going blank, the sound remains but the screen switches off this happens just a few minutes after switching the TV on.


Is this a set sold in the USA? I have never heard of this brand. It sounds as if the back light is shutting off maybe the powe invertors feeding it are breaking down. Or your signal board is going on you. I hope you have aschematic and access to Goodmans parts?

Aug 22, 2008 | Projection Televisions

1 Answer

Toshiba projection tv problem


Hi, you have a failed convergence circuit, you didn`t list model & chassis number so I can`t tell you which IC`s your set uses. this is not an easy job for a layperson that has never done this before, (requires removal of main board and un-soldering two large IC`s and replacing them) If you want more info ask away but be sure to give model/chassis so I know which set were dealing with, good luck, BMW Rider

Dec 07, 2007 | Projection Televisions

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

yadayada
yadayada

Level 3 Expert

60667 Answers

Are you a Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...