Question about Hitachi 42HDS69 42 in. Plasma Television

2 Answers

No pic hitachi 42 hds69 3 blinking lights on back

Have power but no pic 3 out of 4 lights on back circuit board blinking, red orange and yellow

Posted by on

  • Anonymous Dec 29, 2008

    i have the same problem the three blinking lights simuntaniously blinking in the back of the tv plus the led in font blinking

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 29 Answers

Maybe is your Plasma Panel.

The power led flashing??
How many times??

Posted on Nov 28, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 70 Answers

Http://www.hitachi.ca/supportingdocs/en/forhome/plasma_tvs/42HDS69.pdf

Here is the user manual. You may need to call Hitachi.

Posted on Nov 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my ha01371-c flat screen stand by light keeps blinking red


Back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis.
www.electro-medical.blogspot.com

To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement.

Oct 30, 2015 | Flat Panel Televisions

1 Answer

My Hitachi 42" TV the stand by light continuously goes red and blue and won't come on why is this


These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.
If blinks continue without any pause, the main board is faulty.

Jan 31, 2015 | Hitachi Flat Panel Televisions

1 Answer

Hitachi tv won't turn on, only flashing orange and blue light


These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. Viewing it in "Mosaic" or "Magazine" will make surf easy.
http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.

Jul 27, 2014 | Hitachi Flat Panel Televisions

1 Answer

Why is tv blinking 4 red lights and 8 yellow lights


An error code of 48 indicates a main power board failure. There is a short down the 3.3v or 5v switched supply.
recommend replace main power board.

part# 934C409001

see the following website:

http://www.shopjimmy.com/mitsubishi/wd-73c11?cat=59&q=WD-73C11&tv_models=Mitsubishi+WD-73C11

Jul 01, 2014 | Mitsubishi WD-73640 73-Inch 1080p...

1 Answer

Hitachi Plasma 50 inch H4011 series just went off and red light blinked 4 times. Won't come back on even after unplugging and waiting 30 seconds and plugging back in per Troubleshooting guide in owner's...


Power supply board is dead.Replaced the power supply board,Ur tv will get the power back.Tries Shopjimmy.com,Ebay.com to buy a refurbish power supply board for replacement.

Feb 21, 2010 | Hitachi P50H401 50 in. Plasma HDTV

1 Answer

Hi,i have an hitatchi p50t501 plasma and i just put in on and everything was fine,then i put it on video 1 to put on direct tv, then i put it back on cable left the room and the tv light keeps blinking...


The Blue Blinking Light Hitachi.

When the light blinks 4 times it means you can possibly have 4 problems with your plasma.

1. X-Sus
2. Y-Sus
3. Power Supply
4. Sdr U or D

A good way to determine if you can fix this problem yourself is if you can build a PC. If you cant this can cost you upwards of 600$ to fix.

First get a flat area and lay a soft blanket down and lay your TV down so the back is up. Then goto your PC and goto Google and type "P50T501 Service Manual .PDF" you can buy it or if you look hard enough you can get it for free. Next in the service manual it will have a diagram of the Circuit Boards and their locations. Take the back off your Plasma and check the 4 boards. Look for burn marks, cracks, smoke mark. Take your time and look closely. When you find the broken boards unplug it and take the part number and find the replacement online. Plug it in and you should be good to go.

When i had 4 blinking lights i had to change my SDR U and D boards. They cost 100's a piece for Refurbished boards. Keep in mind im a contractor not a techno geek, and i was able to diagnose and fix my problem rather easy.

Aug 15, 2009 | Hitachi P50T501 50 in. Plasma HDTV

1 Answer

7 red flashing lights, won't power up..


Check the power board for capacitors with the tops bulged up. They are 3300uf 10v. There are either 2 or 4 of them depending on your set.

Jun 01, 2009 | Philips 42PF9631D 42 in. Plasma Television

Not finding what you are looking for?
Hitachi 42HDS69 42 in. Plasma Television Logo

422 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Flat Panel Televisions Experts

The Knight
The Knight

Level 3 Expert

68250 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Paul

Level 2 Expert

223 Answers

Are you a Hitachi Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...