Question about Samsung HLR5067WX 50" Rear Projection HDTV

1 Answer

Samsung green lines....

Hey russmann i have a HL-R5667W and i have the same problem but when i unplug the tv and then plug it back in the tv works perfectly fine on all sources....is that the same type of repair or is it the power module? when the green screen is on the hdmi in put is perfect.

Posted by on

  • jean1219 Dec 04, 2008

    Our screen has the picture in the background and green vertical lines about one inch rotating on the screen. The repair shop just told us it will be about $1000 to fix. Apparently they need to get a new digital circuit board and an analog circuit board. Our set is less than 3 years old!!!

  • egguito2000 Dec 17, 2008

    I noticed that my uverse connected on one of the component connections was the only thing i could watch and the picture was perfect. my dvd player, playstation and wii had the green lines on the screen.Tryed switching connections and still the uverse was the only thing visible. now the LAMP indicator is on, so there is no image at all. Is it worth it to change the lamp,,or is the tv pretty much done unless that board is replaced??? by the way my set is also 3 years old and i paid $2k for it and my extended warranty is done.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 203 Answers

From past experience only two things can cause this. First is the cable going from the digital board to the DMD board. Make sure you disconnect the power, and use caution disconnecting the plug or tightening it, not to strip the plastic tension screws. Don't use power screwdriver for loosening or tightening this DVI type cable. Second is the digital board itself that can cause green interference lines in picture. For this, you may consider sending the module, which is the large shielded box where the cable screws on to back of set, out for service or rebuild. Reason being it is cheaper than buying replacement digital board. If it is the board itself, start by running a search on it by part number to see who has one. As I recall, the part number should be BP94-02084A, on your model. Good luck, Russmann.

Posted on Nov 28, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Screen on my HL-R5667W DLP is fading from the left


Ur tv have a convergence problems.The 2 STK convergence ICS are defective and dying.The shop will fix this for u about $300-350 for parts and labors.

May 08, 2010 | Samsung HLR5667W 56" Rear Projection HDTV

1 Answer

My tv has white lines that run up and down across whole screen. it has like 4 lines then a inch space then 4 lines and a 3 inch space My tv is a SAMSUNG HL R5667W


Power supply board, Look for bad capacitors they will be vented or puffed up on Top.
Encompass parts has whatever you need for this model
1-800-638-3328

Mar 02, 2010 | Samsung HLR5667W 56" Rear Projection HDTV

1 Answer

Samsung DLP HL-R5667W not turning on. Showed


Purple spots means Bad Light Engine Part number is BP96-00822J Encompass Parts Has them for
$950.00 - $350.00 core price Part $600.00
1-800-638-3328 Lamp# BP96-01073A

Ballast Board# BP47-00027A

Jan 08, 2010 | Samsung HL-R5667W 56" HDTV

1 Answer

Samsung DLP turns on and off - cycle repeats


make sure put the lamp door back before trying to turn it on because they have switches on them that allow the tv to turn on. If that is ok you probably have a bad ballast.
Call a local tv repair shop to further diagnose the problem.

Dec 10, 2009 | Samsung DLP HL-P5663W 56" TV

1 Answer

I have a Samsung HL-R5667W that is about 3 1/2 years old. The screen is dark except for occasional flickers of light. The lamp appears to be giving off light when I look in the back. I replaced the bulb...


Hi my name is Eric,
I hope I can help you with your issue ,
Most likely your colorwheel is bad,
second possibility is the digital board.
Both are for a technician to install, you could do more damage poking around inside the TV.
 
 
 
If I have helped you with your issue please click accept.
If you have more questions you can still respond until this post expires,
I will reply asap
Thanks
Eric

Sep 26, 2009 | Samsung HL-R5667W 56" HDTV

1 Answer

Samsung HL-r5667w TV shuts down on its own.


You may have a colorwheel going bad. The bearings start going out and this is an indication of the failure. The colorwheel is located in the light engin e therefore you may want to get a qualified tech to look at it

Dec 16, 2008 | Samsung HL-R5667W 56" HDTV

1 Answer

Colored lines and rectangles


Sounds like a problem on the digital board. try hard booting (unplug for 2 minutes) to reboot the microprocessor. if no resolution, look for a new board part # bp94-01859f if your model # ends in WX

Nov 30, 2008 | Samsung HLR5667W 56" Rear Projection HDTV

1 Answer

Samsung dlp hl-r5667w


This Tv make a lot problems with the color wheel and fan thermostat, lamp cool. Need be check the color wheel first. I am suggested dont have nothing on the back cover ( make hot or not ventilation). More information parts at tritronicsinc.com Thank you

Aug 12, 2008 | Samsung DLP HL-P5663W 56" TV

1 Answer

Help with tv


does your tv make noise the bearing usually go out on those color wheel sets so do the lamps on that model if you are confident go for a repair at home here is a shortcut http://www.jangro.com/a/2006/07/24/samsung-dlp-replace-color-wheel/ if this is the year click the link above

Feb 16, 2008 | Televison & Video

Not finding what you are looking for?
Samsung HLR5067WX 50" Rear Projection HDTV Logo

498 people viewed this question

Ask a Question

Usually answered in minutes!

Top Samsung Televison & Video Experts

The Knight
The Knight

Level 3 Expert

71705 Answers

Henry  Thomas
Henry Thomas

Level 3 Expert

1074 Answers

Jerry Greenberg
Jerry Greenberg

Level 3 Expert

1646 Answers

Are you a Samsung Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...