Question about Sharp LL T1620-H (Gray) 16" LCD Monitor

1 Answer

Computer monitors I have just purchased a used Tft monitor and after using it the night before I switched it on the following morning and it powered up ok, then I left it on for 2 hrs max without using it and on my return the screen had gone black so I switched the computer off and powered it up again and the screen was still black but I have noticed a slight clicking sound coming from inside which sounds like a timer running down, as there was no instuctions with this monitor I do not know if there is a timer set on it if I press the last button on the right hand side which I am taking to be the on/off switch the monitor light does not come on , there is a switch on the left hand side rear panel that says 0 and I am taking [I] as on and [0] as off , is this the correct way round or is [0] on would appreciate any info on this monitor or if anyone has instructions to it please would be extremely grateful.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Sharp Master
  • 8,803 Answers
Re: computer monitors

0 and 1 would be zero and one, from the digital world, meaning on and off. This unit needs component-level electronic troubleshooting, probably in the power supply section.

Posted on Jan 15, 2007

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

1 Answer

Fuzzy screen on Gateway FPD1975W TFT LCD Monitor

With the pixels acting up and the monitor having the same problem on any computer that its connected to. The screen itself is bad and since there are no replacement screens for that monitor, you would have to buy a new monitor or get it replaced if its under warranty.

Jun 02, 2010 | Gateway FPD1975W 19" LCD Monitor

1 Answer

Computer 19" LCD Monitor with TFT 1280 x 1024 8ms DVI Connector Integrated Speakers - DYLM1967 ...: After a thunderstorm, my Soyo monitor would not tu...

If it uses AC adapter, then check the DC voltage at the DC plug to see if you get any voltage, if it use Direct power cord then it may have blown fuse inside the monitor, then you will need to open up the monitor.
Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for:
Post back what you see inside so we can guide you further and it will help out other people in the future also.

May 17, 2010 | Soyo TFT 19" LCD Monitor

1 Answer

Monitor blinking off & on rapidly. Just started it out of the blue during use. Turned off computer over night. Still having same problem after re-booting this morning.

Open it up and look at the capacitors. The round "tin can" looking components. If the tops appear bulged, then replacing them may help. Check out the YouTube video... and web site...

Good Luck!

May 13, 2010 | SVA-USA SVA 19" LCD TFT MONITOR

1 Answer

Monitor will not power on - faint flickering when the power cord is plugged in. Gateway FPD1960 TFT LCD Color Monitor


i recommend the following

1) if your monitor has a 3 pin kettle type lead, please replace and see if this sorts the issue, if it is hardwired then unfortunatley your monitor is faulty and will need to be replaced/repaired

Please leave feedback/vote if this has been useful

Feb 10, 2010 | Gateway FPD1960 19" Flat Panel LCD Monitor

1 Answer

HP vs17x flat screen monitor won't come on, blue light flashes.

Try taking on the back of the monitor and pulling the power plug all the way out of it for about five minutes and then plug it back in and restart the computer see if it solved it thanks

May 27, 2009 | HP vs17c 17" LCD Monitor

1 Answer

Monitor wont go on

I just got a new monitor

May 18, 2009 | Compaq Computer Monitors

2 Answers

ACER AL1716S 17"TFT Monitor

Hi, Mine was slow all so. I taken the side panel off and blow it out with a air hose. there was so much dust in it.It is running slow as well. It is very quite know and seems to be alot faster as well. your problem you are talking about i'am sure it was like my problem. needs a good cleaning in side.

May 11, 2009 | Acer AL1715 17" LCD Monitor

1 Answer

ACER AL1916 wont turn on

hi, first aid... check if the power switch is ok on the monitor, and let me know how you confirm the switch is ok???

Dec 30, 2007 | Acer AL1916W 19" LCD Monitor

Not finding what you are looking for?
Sharp LL T1620-H (Gray) 16" LCD Monitor Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sharp Computer Monitors Experts

 Mike M
Mike M

Level 3 Expert

3320 Answers

Robert Rankin

Level 2 Expert

338 Answers


Level 3 Expert

495 Answers

Are you a Sharp Computer Monitor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides