Question about Kenmore 24 in. 17039 Built-in Dishwasher

1 Answer

Water won't pump out at end of cycle

Kenmore 24" built-in 17039 dishwasher will not pump the remaining water out of the bottom at the end of the entire cycle (including the "drying cycle"). Is this a programming problem, because supposedly you can re-program these...however, have lost the manual.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 4,806 Answers

There could be a block in the outlet pipe

regards

and please rate us

Posted on Nov 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dirty water standing in the bottom of the tub


There is probably some debris that is blocking the water from getting to the pump.For More information please visit Kenmore Parts.

Oct 04, 2012 | GE Nautilus 24" Built-in Dishwasher

1 Answer

Green light flashes on clean. Will not run wash cycles. Will drain, Is there a reset button somewhere?


To reset your dishwasher, press the buttons [heated dry] [normal] [heated dry] [normal] to initiate the diagnostic cycle. This should clear the error message from the system and allow it to run again. If the problem persists, check the causes found here : http://bit.ly/gitWix

Mar 05, 2011 | Kenmore 24 in. 17039 Built-in Dishwasher

1 Answer

Clean button won't stop flashing and it won't start, got interrupted mid cycle.


Hello & Welcome to FixYa

Flashing clean light is reset by pressing two buttons in sequence 3-4 times, to reset your kenmore press these buttons in sequence:

High temp wash-heated dry-high temp wash-heated dry

Please get back to me if you have any other questions.

Kevin

Feb 05, 2011 | Kenmore 24 in. 17039 Built-in Dishwasher

1 Answer

My Kenmore elite dishwasher 665.13793K600 has 2 problems: 1. won't drain water 2. won't even start working today Please help!


I have a Kenmore model # 665.13793K600 and it has been having a small puddle of water remaining in the bottom at the end of each cycle. I've taken it apart and cleaned it. I'm thinking I may have the drain hose incorrectly positioned or it could even be something unrelated. I can only think of the drain because I replaced the kitchen faucets a coupe of months ago and it could be since then that this has been happening.

Sep 09, 2010 | Kenmore 24 in. 15079 Built-in Dishwasher

1 Answer

Water remains in bottom of dishwasher


a little water is supposed to remain in the bottom so that the pump will not lose prime when it starts to drain

Oct 24, 2009 | Kenmore 24 in. 16032 Built-in Dishwasher

1 Answer

Dishes not getting clean. I use Jet Dry &


The problem is hard water. Go to www.dishwasherfilter.com. They have a new product out that solves this problem once and for all. It filters the water entering your dishwasher and removes the hard minerals that cause these spots. Very affordable and guaranteed to leave your dishes looking amazing every time.

Oct 21, 2009 | Kenmore 24 in. 17039 Built-in Dishwasher

1 Answer

Some water remain in bottom


In The Manual It States That There is supposed to be some to keep the seals Lubricated. It is normal

Sep 14, 2009 | GE Nautilus 24" Built-in Dishwasher

1 Answer

At the end of each cycle there is a puddle of water at the bottom, it doesnt sound like its pumping properly


Solve at the end of each cycle there is a puddle of water at the bottom, it doesnt sound like its pumping... (More)

Aug 19, 2009 | Zanussi 24 in. DE6544 Built-in Dishwasher

1 Answer

Dish Washer retains the water without draining....


the drain pump is fairly easy to replace. it locks into place beside the sump and motor. push tab in and rotate pump to pull out. you will lose water so have a towel handy. inspect drain hose for restrictions or kinks.

Jun 25, 2009 | Kenmore 24 in. 15079 Built-in Dishwasher

Not finding what you are looking for?
Kenmore 24 in. 17039 Built-in Dishwasher Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kenmore Dishwashers Experts

Fred Sops

Level 2 Expert

271 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Raisin Brann

Level 1 Expert

28 Answers

Are you a Kenmore Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...