1999 chrysler 300m stalls when coming to stop and low power

The symptoms you describe are similar to what I experienced on a 1994 Fiat 900cc. Sometimes it would just die and immediately restart, just to die again. Other times it would surge, almost like a misfire. There were no dashboard lights or error codes.

I disconnected the electrical wire on the MAF (Mass Airflow Sensor) and the car ran pretty ok... so I then replaced the MAF.

Try cleaning your mass airflow sensor to see if that makes any difference. You'll probably find a video on Youtube.

The link below is a generic google search:
chrysler 300 maf Google Search

Check for vacuum hose leaks.

Based on your description, it sounds like you may have an engine siezure. Is there oil in the crankcase? Was the temperature gauge running high before it stopped? Did the engine seem to be loosing power or any instrument lights come on before it stopped?

low port is on left side under hood , remove engine oil dipstick for easy access!

FUEL PUMP ,THAT WHAT IT SOUNDS LIKE

Replace the air and fuel filter. these are the most neglected parts of the car. and part of the most important for fuel economy.
Randy

well, the power steering will freeze when the motor is not running. the mechanic may not find what seems to be the problem specially when no warning lights are coming. you can try replacing the fuel cervo and this will surely help. not everyone knows about this.

poss low fuel or pick up tube in tank broken or has hole in it

mileage on motor?..overheating history?

1999 300M 150,000 Miles

Car dies when coming off acceleration or at idle in traffic or at a stop. I can watch the Tach go to 0 RPM, some times it will restart immediately other times it is hard to start, so far I have always been able to re-start it and Drive on. Does anybody have verified fix for this issue, I have seen posts saying can and crank sensor, throttle body, EGR, and many more ideas... Do not really want to just start replacing parts with the hope that I eventually get a fix. Help...