Question about Power Generators

1 Answer

I need a carb for a es3500 honda - Power Generators

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Power Genera... Master
  • 1,378 Answers

Good place for honda parts is http://www.jackssmallengines.com/index.html. I would try to repair the carb first using a kit containing gaskets and needle. enjoy

Posted on Nov 30, 2008

1 Suggested Answer

  • 1 Answer

SOURCE: Ihave a honda ganerater MODEL#ES3500 and dont know were the battery goes.

The battery '+' attaches directly to the starter and the '-' cable is grounded to the frame/block.

Posted on Dec 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1984 honda big red smoking out the exhaust littel oil coming out tho also it has the wrong carb on it the carb come off a honda atc 200x


If it is black smoke, it could be running rich and the correct carb will fix that. If it is blue smoke, then it is burning oil.

Apr 10, 2014 | Honda 84 Atc200 Big Red 200 Engine Stator...

1 Answer

Honda es6500 won't start has fire,compression , gas, not voltage at carb, oil light on then goes out when cranking


If you run 12volts to the carb, will it run? I assume since it has no power at carb as you stated, that it has a fuel shut off at carb and will need voltage to activate magnet.

Apr 03, 2014 | Honda EU6500iS Inverter Generator

1 Answer

2009 Honda 3000 will not start, we have it in the shop 3 times now, replaced starter and again will not start. We have had to cut short 2 trips now, runs fine for a few days and then will not start. Any...


HONDA MAKES LOUSY CARBS:
Remove the Carberator from the engine...You need to inspect it.
Remove the carb bowl and clean it.
Remove the Float and clean the valve seat seat.
Blow thru the fuel flow areas and see if plugged.
Note: A PC compressed air can works well for this.
There is a steel plug going up to the center of the carb venturi.
This plug get plugged a lot! rust is the problem!
Use a very tiny drill less than .010 Dia to check for rust.
Insert from the bottom up and see if it comes out in the venturi.
If not, you need to hand force the drill upward and clean it out.
Soak everything by spraying carb cleaner in all openings.

note: DO NOT TRY TO REMOVE THE RUSTED PLUG. CLEAN OUT THE HOLE SO FUEL CAN FLOW INTO THE VENTURI. DO NOT DRILL IT OVERSIZE.

Re install the carb...90% of all Honda engine problems is the same.

Feb 09, 2010 | Honda 3000 Watt Portable Generator

1 Answer

Will not get the gas,and it is getting fire 9hp honda generator


try spraying starting fluid in to carb and crank away,itf it woirks then youi need carb work,if it does nothing then check the spark, then the comprussion, should be over one hundred

Dec 18, 2009 | Honda Mmd 5000 Watt Generator W/ Engine...

1 Answer

CONTACT BREAKER GAP FOR HONDA ES3500 GENERATOR SPARK PLUG GAP.


Recommended spark plug is BPR5ES (NGK) W16EPR-U(Denso)
Spark plug gap is 0.7-0.8mm (.028-.031in.)

Air Gap for your ignition coil is .4+-,02 mm(0.016+-0.008in.)

Nov 16, 2009 | Power Generators

1 Answer

220 volt outlet


you can find it in electrical store.

Jul 05, 2009 | Power Generators

1 Answer

On and off switch Honda ES3500


Locate the wire to the kill switch and inspect for disconnected or damaged.

If not...

locate its connection (plug) disconnect it, start the engine, insert a small screw driver into the plug that leads into the engine assy. and ground it to the engine to check that it stops the engine. If so the switch is not grounded or faulty.

If not...

That circuit is damaged inside the housing.

Those switches operate by grounding the signal to the coil to stop the spark.

On position = open/not grounded

Off position = closed/grounded

I hope this helps...Good luck
Aduz


Mar 15, 2009 | Power Generators

1 Answer

Gas in the oil on my honda generator


Your needle/float is stuck, which will allow fuel to flow though the intake...past the piston..and into the crankcase. If has been awhile since you used it, most likely the gas has gummed up the insides of the carb. Otherwise, you may have had something get into the fuel bowl that is keeping the needle from closing. Best way to solve is to remove and clean the carb. Replace fuel filter if needed also.
Hope this helps

Mar 11, 2009 | Honda 3000 Watt Portable Generator

1 Answer

Ihave a honda ganerater MODEL#ES3500 and dont know were the battery goes.


The battery '+' attaches directly to the starter and the '-' cable is grounded to the frame/block.

Nov 03, 2008 | Honda Power Generators

Not finding what you are looking for?
Power Generators Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Power Generators Experts

John Trevino

Level 3 Expert

1378 Answers

EugenesDIYDen
EugenesDIYDen

Level 3 Expert

479 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Power Generator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...