Question about Viking VGRC485-6 Gas Kitchen Range

1 Answer

Burners from main oven do not turn on VGRC485-6QDSS

Is there a spanish speaking person and a telephone number were I can call to get answers???

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 311 Answers

No spanish, but ignitors in oven are worn out if they glow and flame is slow or does not come on. They would need to be replaced. I have them on-hand if you want them. I cannot see your repyl due to some tech issue w/ the site, so it may be a day or so before I can reply again. Please leave feedback for me if appropriate. Thanks

Posted on Nov 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Had oven set at 500 degrees. Turned off all burners and oven, but the broiler remains on! What do I do?


Hello. It sounds like you have a shorted relay on the main board(if this oven has an electronic control board) keeping power on to the broiler element. I need the make/model number to help you further and accurately.

Sep 20, 2015 | Kitchen Ranges

1 Answer

I have a Hardwick propane stove, 4 burners and oven. The stovetop burners work fine (need a match), but now the oven does not ignite despite the pilot light working fine. I have brushed the pilot light...


Hello Patrick,

WHen you turn on the oven/broiler does the size of the polot ligh increase in size??
the way it is suppose to work is...thier a small free standing polot light and when ya turn on the oven the size of the pilot is suppose to increase and heat a little bulb that is connected to a wire that is mounted to the pilot burner and when that bulb heats up it will allow the main gas to flow into the oven(not pilot burner).

If the size of the pilot does not increase it could be caused by a clogged pilot burner. the way to determine that is TURN OFF GAS SUPPLY...disconnect gas line from pilot burner and turn on gas to unit, light that tube with it disconnected from pilot burner and turn oven on and see if size of flame drastically increases...if it does turn gas off and remove and replace pilot burner
if flame sizedoes not increase the problem is going to be the thermostat

If the pilot does increase and heats the bulb on the pilot burner the problem will be with the gas valve that,that bulb in the pilot burner accathes to is bad .

now chances of the thersostat still being available is very slim if the pilot burner is clogged and needs replaced they are still available their is 2 of them one has the mounting plate on the left and one is on the right.
here is what they look like

oldtech2332_148.jpgPart number for this one is 1898-021 notice how the mounting tab is on the right

oldtech2332_149.jpgthis one is pt# 1898-022 the tab is on the left

That when performing a quick search on google is pretty much all that still available teh thermostat (would need model number) is doubtful to find also a good chance the gas valve is also no longer available

Good luck,
GENE

Oct 27, 2011 | Kitchen Ranges

1 Answer

Pilot relighting Garland Commercial range


The main burner valve is the oven valve. The pilot will be next to the burner and you either have to insert a long shiskabob stick ( lit) into the hole or lift up on the bottom of the oven (inside) and you will see the pilot.

Feb 09, 2010 | Garland H286 Gas Kitchen Range

1 Answer

Magic chef oven pilot light out


Hi, If the oven has a standing pilot too, Open the bottom door and locate the main burner. Follow the burner toward the rear of the oven and there will be a flame switch attatched to the burner. Hold the flame near the flame switch and the gas should ignite.
Some model do not have a standing pilot in the oven. Please get me your model number off the label located around the opening of the lower door so I can look this up and instruct you better.

Vic

Jul 15, 2009 | Magic Chef 31000 Gas Kitchen Range

1 Answer

I meant to push broil, but pushed clean and my food is locked inside. How do you cancel the clean?


Look at following areas for the model number
  • Under Right Front Burner
  • Under Left Top Burner Front Or Rear
  • Under Main Top Left, Rear Or Center Front
  • Under Left Rear Or Right Front Element
  • On Nameplate Inside Burner Box
  • On Front On Burner Box Bottom
  • On Nameplate On Oven Door Liner
  • On Main Front Behind Oven Or Compartment Door
  • On Front, Center Bottom Of Burner Box
  • On Thermostat Cover Under Main Top
  • Get me the model ,number for your oven and I will be able to help you better, Thanks, Sea Breeze

Mar 29, 2009 | Maytag MER6772 Gemini Electric Kitchen...

1 Answer

Oven is not heating properly


Could you find the completer mode number because the number listed above your post is for a gas oven.
Look at following areas for the model number
  • Under Right Front Burner
  • Under Left Top Burner Front Or Rear
  • Under Main Top Left, Rear Or Center Front
  • Under Left Rear Or Right Front Element
  • On Nameplate Inside Burner Box
  • On Front On Burner Box Bottom
  • On Nameplate On Oven Door Liner
  • On Main Front Behind Oven Or Compartment Door
  • On Front, Center Bottom Of Burner Box
  • On Thermostat Cover Under Main Top
  • Thank You, Sea Breeze

Mar 25, 2009 | DCS RGS-484GG Gas Kitchen Range

2 Answers

Magic Chef LP range produces soot whenever oven is on.


The vent (shutter) allowing air to mix with the gas has shut. Access the burner with the oven off, of course, and look for the shutter (a sliding 'door'). It usually has one screw holding it n place and an elongated slot to permit adjustment. It may also turn. Since your burner is producing soot, you need to open the shutter more. Loosen the screw and slide the shutter open more. Turn the oven on and look for a nice blue flame, and one that doesn't run too far over the burner. Keeping in mind that everything there will be hot when the burner is on, and also for a long time after it is off, you can use a long-bladed screwdriver to push the shutter back and forth to get the flame you are looking for. If the screw is loose, a gentle tap will be enough. When you are see that optimum blue flame and you are satisfied, let the oven cool off for an hour or so, and final tighten the screw--making sure you haven't moved the shutter much when tightening. If this doesn't work you have a bigger problem and need to call a service person. Your local gas company sometimes will direct you to a person.

Dec 08, 2008 | Kitchen Ranges

3 Answers

Mabe gas range


I HAD JUST PURCHASE A MABE 30' GAS FREE STANDING RANGE AT A LOCAL STORE HERE,THE BURNERS WERE ABSENT BUT I WAS ABLE TO SOURCE THEM AT THE MAIN BRANCH,I AM ALL THE WAY IN JAMAICA.I HOPE YOU CAN SOURCE IT,IF NOT FEEL FREE TO LINK ME UP AT fidel_perry28@hotmail.com,i will pass on the relevant info.good luck.



FIDEL

Jul 24, 2008 | GE Profile Spectra JGBP90 Gas Kitchen...

2 Answers

GE GAS RANGE OVEN PROBLEM


two options.first does the pilot flame look good (a nice blue flame)?if so you will see a metal probe next to the pilot,use some sandpaper and clean that probe up.if that solves your problem so be it.second if the first thing doesnt work its probably the ignitor board not sensing the flame.the way to definitly tell the one or the other use a small torch and heat up the probe like i said and turn the oven on.if the main burner comes on then you know its the probe which is called a thermocouple and is cheap.hope this helps.

Aug 08, 2007 | GE JGBC20 Gas Kitchen Range

Not finding what you are looking for?
Viking VGRC485-6 Gas Kitchen Range Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Viking Kitchen Ranges Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

paulcarew

Level 3 Expert

1898 Answers

KJ4QOB

Level 2 Expert

55 Answers

Are you a Viking Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...