I want to upgrade my HP BA 600 Mother Board`s RAM Capacity

One easy way to find out for sure how much RAM your computer can hold is to go to WWW.CRUCIAL.COM and run their SCAN MY COMPUTER feature.

This handy utility will scan your hardware configuration and tell you exactly how much RAM memory you currently have installed and what type it is.

It will also tell you how many RAM slots are fitted on your motherboard and what the maximum memory capacity for each individual slot is, as well as the maximum total RAM that the motherboard can handle.

If your computer does have room to add more RAM, it will provide you with specific recommendations as to exactly what type and size of RAM stick to buy in order to maximize the memory capacity and performance of your computer.

Thank you very much and good luck.

the RAM upgrade will depend on ur motherboard capacity and specification.
u need to check ur MB manual
if ur MB can have only SD RAM then only SD RAM upgrade is possible...DDR will not work....
so be careful while buying ur RAM

intelD845GLLy MB...the following details are from the intel website

http://www.intel.com/support/motherboards/desktop/d845glly/sb/CS-012825.htm

System Memory Features
The D845GLLY board provide the following memory features:

• Two DIMM sockets supporting 3.3 V (only) 168-pin 133 MHz Single Data Rate (SDR) SDRAM DIMMs with gold-plated contacts
• Unbuffered non-ECC DIMMs only
• Maximum total system memory: 2 GB; minimum total system memory: 64 MB
• Serial Presence Detect (SPD) DIMMs only
• Suspend to RAM

Caution Do not use ECC DIMMs with the Desktop Board. Using ECC DIMMs could damage the Desktop Board.
Integrator's Notes:

• Registered DIMMs are not supported on the Desktop Board.
• This Desktop Board has been designed to support DIMMs based on 512 Mbit technology for a maximum onboard capacity of up to 2 GB, but this technology has not been validated on this board.

Note To be fully compliant with all applicable PCI33 SDRAM memory specifications, the board should be populated with DIMMs that support the Serial Presence Detect (SPD) data structure. This allows the BIOS to read the SPD data and program the chipset to accurately configure memory settings for optimum performance.
hope this helps
Reg....bye

Your system has a maximum capacity of 2 GB of SDRAM - 266.0 MHz

Since it supports 120GB, it will support any "large" SATA drive, such as 500GB or twice or three times that size.

Well with this type of motherboard yes you can put 1gb into it however you can put up to 2gb on it and be just fine. Hope this helps you out.

hiya

this board is ddr so you will need ddr400 or pc3200 and a maximum capacity of 2gb so be carefull with 1 gb sticks as sometimes this causes system crashes

hope this helps

Regard Rik

YAS IS GOOD YOU CAN UPGRADE YOUR MEMMORY TI 1GB ALL YOU NEED TO DO IS GET THE EXACT TYPE OF WHAT YOUR MOTERBOARD IS USING eg IF YOUR MOTHERBOARD IS USING DD RAM GET 1GB DD RAM IF IT SD RAM YOUR BOARD USES THEN GET SD RAM. IT GONNA BE FINE WHEN YOU UPGRADE IT WILL PARFECT YOUR PC PERFORMANCE.

this is the link

http://www.memorystock.com/memory/ToshibaSatellite2400103.html

In this link u have following details
1)Maximum capacity RAM Information Available
2)Toshiba Laptop Memory Installation Video
3)Laptop Memory SODIMM Installation Guide

If you r Satisfied with information provided from my side please give me good ratings thanks
If u require more information search in google

The video card is NOT upgradeable.

the system should support a 120 GB HDD

NOTE: This system is old enough to be considered operationally obsolete and not a good candidate for an upgrade. Especially with new portables starting at $499

http://www.dell.com/content/products/productdetails.aspx/inspnnb_1525?c=us&cs=19&l=en&s=dhs

Yes, your board will support 320gb. I am not aware of a limit to how many gigabytes you can have per computer. I currently have 1.5 terabytes. 1500gb.