Hp color laserjet 2600n ''black print down form its orignal place''

54.06

Error message

54.06

Description

Color density sensor error

Action

1. Power cycle the printer.
2. Calibrate the printer. Click here to view the document "HP Color LaserJet 2600n - Calibrating the printer" available on the HP Web site at (http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00314525).
3. Change the Print Density settings through the HP Toolbox. Click here to view the document " HP Color LaserJet 2600n Printer - Change Device Print Settings in HP Toolbox" available on the HP Web site at (http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c00310627).
4. If the problem continues, contact HP Customer Support Center for technical assistance athttp://www.hp.com/support/clj2600n or see the flyer that came in the printer box for additional contact information.

You can but it would have to a manual. Meaning you print out the document and load it into the manual feeder to print the other side.
Your installed driver should support duplex printing so once the document print on the one side the machine will prompt you to place the document in the manual feed tray.

It a problem with printer fusing assembly. so you can checked it from service center.

Could be down to dirt contamination in the laser scanner

There is an override sequence and it works well. Press the select button (checkmark) to indicate Main menu. Press right-arrow (RA) to select System Setup. Press Select , then RA to Print Quality, Hit select. RA to Replace supplies and hit Select. Now, RA to Override Out and Select. Confirm with Select again. Your 2600n will now run even with an empty toner cartridge.

replace fuser,if still happening replace transfer belt

it will be better if you tell the vendor for repair or replacement

look at the red cartridge do you see any dots on it ? is it only when you print? what about if it's just Blk & wht?

TRY TO REMOVE ALL THE CARTRIDGES FROM THE PRINTER . CARTRIDGES WHICH ARE NOT WORKING SLOWLY SHAKE THEM UP AND DOWN WITH YOUR HAND TAKE CARE IT DOES NOT GET BANGED SOME WHERE AND REINSERT THE CARTRIDGES SLOWLY ONE BY ONE THEN TRY PRINTING IF STILL DOES NOT PRINT, YOUR CARTRIDGES MUST HAVE GOT OVER SO CHANGE THEM IT WILL START PRINTING.WISH U GOOD LUCK.

you probably needt o change the transfer belt which is the "black roller film". you can try wipping it off with a dry lint free cloth.