Stony LCD 2007 goes off and screen comes on saying it needs projection lamp. Is this something I can replace myself ?

Yes you can replace Lamp yourself! look on back of TV and write TV model number down. A lamp code can also be found on back of tv or located near Lamp DOOR.Easy replacement!

the best thing to first is to replace lamp ..lamp will also cause this..this will be the cheapest route to go first..Please let me kno and I will give you more info or docs from Sony...

You can by the lamp online from various outlets. They usually run around $150 to $200 and are pretty easy to install at the back of the television. Make sure the TV is unplugged and use a screwdriver to remove the outer cover and loosen the lamp housing. Disconnect the connector and install the new lamp. Re-install the screws. take special care not to touch the lamp because your skin oils can cause the lamp to fail. Make sure you go into the menu for the televison when your done and rest the lamp timer.

Here is a link to a web-site that sells lamps. Definently shop around prices can very greatly.

http://www.dlplampsource.com/?gclid=COi-7Lie45wCFRgbawodlFdUmg

even though the lamp light is not flashing I would think it is the lamp getting weak for some reason the Sony's do that.

It is a defective light engine and is not a user replaceable part. In most case the part will cost close to 1000 if not more.

Check the lamp. Other than replacing the lamp there are no user servicable parts.

It is likely the projection lamp is weak, causing the picture to cycle on and off. Take the lamp out and examine the reflector. If it is dull and cloudy, it's time to replace the lamp. A new lamp will have a reflector that is shiny and looks like a mirror. Be sure to rate this solution. Thanks!

when lamp goes out frequently.

all lamp filters need changed...call tech

I had a similiar problem... I had to replace my bulb, which means $$$!

Blue lcd is burnt up.. Normally happens due to excess heat from poor ventilation or not changing the lamp at the required time.. Allways happens on the blue as blue light is the hottest wave length, and as the lamp burns, it shifts to that side. Nothing you can do but replace the lcd itself. From the image shown, looks like the unit uses sony lcds.. Sonys are well known for there burns.. No quick fix on this one.