Question about Motherboards

2 Answers

Error message system cannot booting, Error message is Chasis intruded- fatel error system halted Hi I have Problem, when i boot PC show message error " CMOS Checksum Bad, Chasis Intruded Fatal Error System Halted" and i am cannot login BIOS menu if i press DEL or F2

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 183 Answers

Open Your system and there is a Battery which looks like a Coin. that is CMOS Battery (CR2032) Change that battery and then Reboot your system and try go to BIOS menu with DEL , F11 , F1 or F2. Either of these Buttons can Work.

This will resolve your issue

Posted on Nov 27, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 122 Answers

Is the BIOS Password protected? Have you tried taking the battery out for a few minutes then re-installing and then go into the BIOS and change the Intrusion setting / reset BIOS

Posted on Nov 27, 2008

1 Suggested Answer

teknowolf
  • 207 Answers

SOURCE: Error Boot "Chasis Intruded fatal Error System Halted"

Achdi,

Something has tripped the chasis intrusion on the motherboard.

This is a security device that disables the system should someone unauthorized open the case.

Unplug the power supply, open the case. Down near lower edge of the board there is a connector with several wires attached marked Panel a bit farther up from that there is one marked CHA_FAN between that is one marked CHASIS this is the connector we need to deal with. If there are wires attached to it trace them back to the module attached to the case. there should be a reset switch on this device be sure to reset it just before closing the case again. If you can not find a reset switch on it remove the wires from the connector and tuck them away (Note doing so will mean the intrusion detector will not function any longer) If there were no wires look carefully to see that nothing has shorted (connected the pins) accidentally. If so it might be advisable to blow out the case with a can of compressed air to prevent it from happening again.

OK now we need to clear the fault from the bios. There is a battery (Silver disc: watch style) on the board. Pull the battery. Now there is a 3 pin connector near the battery marked "ClearRTC" that has a jumper on pins 1&2 move it to 2&3 now wait for 15 to 20 seconds
restore the jumper to pins 1&2, replace the battery, close the case.If the intrusion detector is still functional reset it. Plug the cord back in and boot up the PC you should now be able to get into it.

You will have to go into BIOS to adjust settings again including set time and date.

If this method does not help then the error is likely internal on the motherboard, and will need to be repaired or replaced by an authorized service tech.

Hope this helps
Dave

Posted on Nov 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

The problem of my computer is when i open my computer its not boot to windows it shows chassis intruded fatal error-system halted! what can i do to solve that problem? my board is asus p5sd2-vm.


chasis intrusion is an option in the bios, when U start the pc, press dell to go into the bios, walk trhough the settings ( I think it will be in a section advanced or security) where U can switch off intrusion.

Did U open the case recently?

Jun 16, 2011 | ASUS COMPUTER INTL P5SD2-VM MBD MATX LGA...

1 Answer

A massage display when started pc - chasis intruded, fatal error


enter the BIOS and turn of the chasis intrusion warning.

Jun 06, 2010 | ASUS P5GC-MX/1333 Motherboard

3 Answers

Chassis intruded ? fatal error... system halted in asus p5sd2-vm mother board


first you have to check the RAM,, then mother board or processor,, ,,, make sure the pc while booting memory check is going with out problem..s

Sep 29, 2009 | ASUS P5GC-MX/1333 - Motherboard - micro...

1 Answer

My system can not booting error message is chasis intruded fetel


KINDLY QUOTE THE EXACT ERROR MESSAGE YOU ARE GETTING. Start tapping the del / f2 key immediately after you turn on the system

Aug 26, 2009 | ASUSTeK P5K Desktop Board - Core 2 Extreme...

2 Answers

ASUS P5VD2-VM SE MOTHERBOARD


If you purchased this motherboard recently then i would double check your power supply - get a better power supply and try that - think you may need one with two 12 volt rails.

If that does not work then I would get it RMA'd as in return it and get a replacement.

Apr 10, 2009 | ASUS P5VD2-VM SE - Motherboard - micro ATX...

2 Answers

Chassis Intruded, Fatal Error...System Halted


you need to go into the bios of your pc.....usually pressing the delete key when you see the first logo screen after booting up....look for a section that relates to errors and what the bios is supposed to do when it encounters an error.
i.e if you see a line in the bios that says "halt on all errors" disable it and when you next boot up the bios will not stall.

Mar 20, 2009 | ASUS P5GC-MX/1333 - Motherboard - micro...

1 Answer

Asus k8s mx mother board problem


To get rid of this message at boot you must turn off the Chassis Intrusion detector feature. To do this you must restart the computer, as it boots press DEL to enter BIOS.
Under the SECURITY tab in BIOS select CHASSIS INTRUSION and select DISABLE.
Then select EXIT and SAVE CHANGES and OK to reboot the system.

Jan 31, 2009 | ASUS K8S-MX Motherboard

3 Answers

Error Boot "Chasis Intruded fatal Error System Halted"


Well it seems like that the cmos battery is down. You need to do the following

Change the CMOS battery,
Enter into bios and change the date and time properly,
Save and exit bios.

Now you should be able start your computer in windows.

Nov 26, 2008 | ASUS P5P800S Motherboard

1 Answer

Error message


There is a micro-switch which detects when you remove the lid.
This can be disabled in the BIOS menu.
Switch on and press F2 or DEL key until you get to BIOS Menu (may ask for password).
Then find security menu and disable intruder alarm enable.

Aug 17, 2008 | Motherboards

2 Answers

Chasis intrded fetal error system halted problem plz hep me


somewhere on the motherboard there should be a switch or jumper to turn it off look for directions either on case somewhere or on motherboard

Jul 30, 2008 | ASUS SiS Chipset P5S-VM Motherboard

Not finding what you are looking for?
Motherboards Logo

Related Topics:

1,129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Motherboards Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

joecoolvette
joecoolvette

Level 3 Expert

5660 Answers

Mark Taylor
Mark Taylor

Level 3 Expert

728 Answers

Are you a Motherboard Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...