Question about Xerox WorkCentre XL2130f Laser Printer
When i go to print something from computer the paper comes out all black. when i hand feed a piece of paper to make a copy of something the left hand side comes out with a smudge of black down the page and the printing that comes out is really small.
sounds like the registration clutch is sticking, unplug machine. the reg. clutch is located in the middle of the machine, under the drum unit, it should have about 4 little gray rollers on it, @ the rear of the shaft in the back part of the machine you will see the reg. clutch. take a little bit of alcohol and pour it over the clutch and move the roller to get the toner/dirt out of the clutch. let the alcohol dry. try machine.
Posted on Nov 03, 2007
when this occurs the problem is most of the time with the transport roller, fuser / fixing assembly roller.question is the image still toner only and not fused to the paper.
In these areas there is offen a jammed and not removed piece of paper dislodged in the paper path or jammed in the fuser or the transfer rollers teflon coating has perished inspect the areas carefully and remove any found if the unit still is faulty (fanning of paper the fuser would be the first to be replaced are past there usable life) if so then Post a reply
Posted on Nov 04, 2007
That really sounds like you need to replace the maintenance kit.
The white roller most likely is black and has depleted itself of lubricant a bit prematurely.
Posted on May 21, 2008
SOURCE: Lines along edge of paper
If the problem re-appears and updating the firmware (from office.xerox.com) does not help you are most likely looking at a replacement processor board.
Posted on Jul 28, 2008
SOURCE: paper folds and jams before
your description points to a fuser assembly problem which is right where you looked. I'm not sure what that plastic piece is from. if it is black, it probably came from the fuser. That is a replaceable part, but I'm not sure you can still purchase them from Xerox.
Posted on Aug 26, 2008
Try using the PCL driver from the Xerox website, rather than the Postscript one supplied with the printer.
I had the same problem and installing the PCL driver solved it.
Posted on Nov 26, 2008
Tips for a great answer:
Aug 05, 2012 | Printers & Copiers
Sep 02, 2010 | Samsung Printers & Copiers
Jul 16, 2009 | HP OfficeJet 7310 All-In-One InkJet...
May 06, 2009 | Canon PIXMA MP510 All-In-One InkJet...
Mar 24, 2009 | Lexmark X4530 InkJet Printer
Oct 25, 2008 | Sharp AL 1215 Black and White Copier
Oct 20, 2008 | Lexmark Printers & Copiers
Mar 28, 2008 | HP LaserJet 1100 Printer
Feb 01, 2008 | Canon PIXMA MP470 All-in-One Printer
Sep 05, 2006 | Dell 922 All-In-One InkJet Printer
63 people viewed this question
Usually answered in minutes!