The Printer starts printing, stops half way then spits out without prining the rest of the page

i aint too sure if its the same but i had an epson printer with the same problem last year it would print half a page spit out and then print the same half a page again and just stuck in a loop even on printing disks it did the same i found out after by speaking to a printer specialist it was the printers eeprom which is the printers memory bank that was failing and nothing can be done with it

Check your print driver settings. And if you are printing from any of the microsoft office applications look at the page setup to see if something was changed. Click file, then right near print is the page setup.

this is mostly due to wrong drivers installed on your system. try reinstalling the drivers for your printer if the drivers are correct check virus on your computer. there is a small printer spooler virus that causes this to happen.

Carefully check all the paper driveway and also cartridges: something is still on the way

http://www.fixya.com/support/t3934542-exit_sensor_problem_samsung_clp_315

dear sir good day this printer have a common problem in the separation pad part and it need to simply replace ... so please take your printer to the tech company to replace it for you or buy it from it ((mention the printer model for the co.)) and download the service manual from the printer manf. site and do simply install the spare part and it'll work thank you

You'll probably have to replace the exit sensor (lots of people have this problem). Go to YouTube and watch this video: 5fJHykzkfww

You can get the part on eBay for about $10 and it's a fairly simple 15 minute fix.

Try printing pages 1 through 25, let printer cool down, print pages 26-46. I'm, thinking it's a print head overtemp problem. If the second printing will not do the complete 26 to end, let the printer set for a longer time to cool off and try again.

Go to START, Printer & Faxes, right click your printer and select properties. Under the advanced tab, click seperator page, delete whatever is in the box and click OK. This should stop the blank pages from printing.

Hope this helps

-samson39

i think you have aproblim with the main card in side the printer