Question about Mitsubishi WS-55511 55" Rear Projection Television

1 Answer

I have a toshiba laptop

There is line going through the center what happened?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 505 Answers

If you have a row of stuck on or off pixels, then you have a bad LCD panel.

Posted on Dec 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lines across bottom of screen


are they blinking lines or just straight across from one side to the other blinking lines is the dlp chip going ( they cost a bit to replace)
no blinking then the mirror could of moved in the back of the tv, happens if the tv is not on level ground. or the dlp board needs adjustment ( happens over time as the plastic moves when hot to cold all the time)

Mar 16, 2013 | Toshiba 52HM95 52" HDTV Projection...

1 Answer

Hello..Toshiba 51HC85, 2005 model. Turn on TV and verticle wavy lines appear until TV is warmed up completely. After warm up the picture is great again. Any ideas?


I've had the same problem for about the last 6 months. My workaround which was to leave the tv on 24 7 and just turn off the TWC service box. But now the symptoms are vertical dark lines going all the way across screen. My guess is that it will cost more to fix than worth it. I paid @$2000 for it new in 2004. Technology has gotten better so I may just go out and get a Samsumg for considerably less and be way better off. None of Toshiba's products had done well for me. 2 laptops, 3 tvs, etc. have taught me this.

Sep 20, 2010 | Toshiba 51H83 51" Rear Projection...

1 Answer

It has lines when it 1st get turned on and it


Several capacitors need replaced in the Hyper Module. It's not something the consumer can repair and the module is not available any longer as new or rebuilt. You should call a service center for an estimate and decide whether to put the money into it.

Dec 06, 2009 | Toshiba 42H81 42" Rear Projection...

1 Answer

Red convergence is not lining up with blue wat those that mean


go into menu and adjust convergence. if red moves, it just needs adjusting from your remote. if it doesnt move or is bent then you have a bad convergence ic. possible fuse. suggest local service center. sorry

Nov 10, 2009 | Toshiba TZ61V61 61" Rear Projection...

1 Answer

I have a yellow line on the right side of my Toshiba 50 rear projection TV and yellow shadows around people


It sounds like a convergence problem---go into the customer menu and select convergence---set should offer center and multipoint adjustment--in the multipoint look to see if the outer crosses adjust--if red or blue will not adjust somewhere--bad convergence IC's.

Jul 17, 2009 | Toshiba 42H83 42" Rear Projection...

1 Answer

Vertical Lines that occur for the first 5 min the tv is on


sounds like you have sa bad what is called the hypermodule. ideally the best coarse of action would be to replace this. but do to the fact it is a common problem these cuircit boards are hard to come by. Toshibia has told us service centers how to repair these boards which involves replaceing 11 micro caps very very small compnents that usally involve twezzers and magnifier. not for the do it yoursefer. you can easlly damage the board and if that happens that ends the tv right there. at my shope such a repair runs 250 with the parts and labor but it will depend on the shop it is rather labor intensive even to remove the board

Jun 19, 2009 | Toshiba 65H84 65" Rear Projection HDTV

2 Answers

Toshiba 57h81 green will not focus


Typically this is a convergence problem and can be repair relatively easy. Refer to this video to determine if you truly have a convergence problem. Also make sure you use your TV's original remote to make this adjustment.

Nov 15, 2008 | Toshiba 57H81 57" Rear Projection...

1 Answer

Toshiba DLP 46HM95 - blanking out issue


I am assuming that when the set blanks out, you don't notice the power light flashing any certain sequence. What I would try if that is the case, would be to press a button on the remote control to bring up a menu on screen when it blanks out. If you can bring up any writing on screen while the picture is blanked out you know the Lamp is doing its job. Also, do you lose audio when this happens? If so, it could be a problem in the power supply or if you have the cable connected directly into the TV's tuner stub, the problem might lie in the Tuner. If you have On Screen Display when this happens and audio, then it looks like there is a problem in the video circuits of the TV. If you have a cable box hooked into the TV, the problem could be there also. Now you know why the Toshiba Repair Center gets the big bucks to figure out these things.

Mar 12, 2007 | Toshiba 46HM95 46" HDTV

1 Answer

Center screen convergence problem


The convergence adjustment on the TV set are for the center adjustments ONLY. if you cannot get them in or they are way out, then you have a convergence IC problem. Dont feel bad though as it happens to every rear projection set ever made. Good Luck

Dec 30, 2006 | Toshiba 53AX62 53 in. Rear Projection...

Not finding what you are looking for?
Mitsubishi WS-55511 55" Rear Projection Television Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Projection Televisions Experts

matt martin
matt martin

Level 3 Expert

1191 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

The Knight
The Knight

Level 3 Expert

68223 Answers

Are you a Mitsubishi Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...