Question about Panasonic Microwave Ovens

1 Answer

Microwave cooks for 30 seconds then turns off

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Panasonic Master
  • 8,820 Answers

If it stops after 22 seconds, that means the controller has detected a problem, usually a problem with the inverter or a bad magnetron.

Due to the lethal voltages used and produced, I do not recommend that an inexperienced person work on these.

You can find an authorized Panasonic servicer here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Posted on Nov 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Genius S333 refer to manual error after 3 seconds


If microwave runs only without turn table, I am suggest to check if turntable electric motor has got short circuit. If yes, I have some left.

Nov 13, 2013 | Microwave Ovens

1 Answer

How can I cook for 20 seconds in SANYO MICROWAVE 1250W EM-S2587V


Go to www.sanyo.com contact customer support and the technical department to see it they can offer a solution to set it below the 30 seconds.

May 28, 2012 | Sanyo Microwave Ovens

1 Answer

My microwave want cook


Hello

and/or circuit breakers, particularly in the case of recent power failure, and reset if necessary.


Unplug the microwave, wait 30 seconds and plug back in to the power supply to reset the microcomputer.


Open and close the microwave door firmly and press "Stop/Reset." Select a new cook time and press "Start."


Ensure a proper cooking temperature and/or time is chosen, as low cooking temperatures or short cooking times may prevent the microwave from heating food appropriately. Press "Power Level" to ensure the microwave is cooking at 100 percent power.


Contact an authorized service technician if the problem is still unresolved.

Oct 04, 2011 | Sanyo Microwave Microwave Oven

1 Answer

I have a 15 year old Toshiba microwave which I may need to replace. It can be set to cook in single seconds (eg for 23 or 38 seconds) a facility I find essential. Many new microwaves it seems can only be...


I believe the dial on Hobart microwaves allows you to manually enter any amount of time by spinning the dial for the desired time, and programmable buttons to save the time settings. HL1600 is 1.5 cubic foot, 44 liters

Feb 11, 2010 | LG LMVM1935 Convection/Microwave Oven

2 Answers

I have Emerson Microwave #mw8999sv which has the Express Cook option- cooking 1 - 6 minutes. How do I cook for 1 minute 30 seconds, etc.? Thank you.


The owner's manual is here. On page 10 we find:

COOKING IN ONE STAGE
1. Press the POWER button; the Microwave and High
Cook indicators will light and “PL 10” will light in the
display.
2. Press the POWER button different times to set the
desired power; the display will show the percentage
you chose. If selecting power level 70%-10%, the
Low Cook indicator will light instead of the High
Cook indicator.
3. Press number keys to set the desired cooking time.
OPERATION(CONTINUED)
4. Press the START/+30SEC. button to start cooking;
the Microwave and one of the Cook indicators will
blink and the display will countdown the remaining
cooking time in minutes and seconds. It will beep
five times when cooking is completed.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.


Sep 08, 2009 | Emerson Microwave Ovens

1 Answer

Instruction Manual for Sharp Microwave Oven


I can explain that. You enter the power level you want from 0 to high(10) the number corresponds to a percentage of time the cook cycle is ON. 5 being 50%, for each minute of cook time programmed the magnatron will be on 30 seconds and off 30 seconds. You can program anything from 10% to 90% in place of the high or "always on" setting. Eric

Sep 06, 2009 | Microwave Ovens

2 Answers

Egg cookers


I found the instructions
Sprinkle a few grains of salt on bottom of egg cooker. (Salt attracts microwaves and is necessary to help cook bottom of egg)

Break egg into egg cooker.
One egg in micro at a time.

Will fork piece yolk and white to bottom of cooker, three times. _ This is very important.

Line up notches on egg cooker lid and cup then twist until locked

Micro on High for 30 seconds

Let stand 10 seconds
If bottom of egg is not cooked turn egg over with a spoon and microwave on high for another 10 to 20 second or until cooked.

Dec 16, 2008 | Microwave Ovens

1 Answer

Microwave works for 30 seconds and then turns off


The first thing to try is a "hard reset". Unplug it from the power line for a few minutes, plug it back in, set the clock, then try again.

Let us know if the hard reset doesn't fix it.

We're happy to help and we appreciate your thoughtful rating of our answer.

Apr 23, 2008 | Microwave Ovens

1 Answer

GE Profile turned off as soon as it start


If you can program it and the problem occures when you push START. Then the problem is a door switch, or the control panel not having a completed circuit. Think of your control panel as an off-on switch.COOK, the control panel switches on for 100% of the time programed. DEFROST,The control panel turns the Cook-Relay on for 30% and off for 70%, on, off, on, off,for the time you programmed for DEFROST. This is how it works. There is no lowering of the output. The output is 100% anything other than COOk is done in % of time on, % of time off. This is why you can hear a "Bump" when Defrosting. The "Bump" is the Cook-Relay sending power to the High Voltage Side, 30% on, 70% off.

Jan 22, 2008 | GE Spacemaker JVM1640SJ Microwave Oven

1 Answer

GH7145XFB-1 not heating properly


Generally, the most common causes of a failure to heat are:

- bad door switches or door switch mounts
- loose connection at the magnetron
- problem or loose conneciton on the control unit circuit board
- bad magnetron or other high voltage part

If you or a friend decide to look into it, we have critical safety information, info on door switch diagnosis and replacement, and disassembly information at our site, linked here on Fixya: http://tinyurl.com/yzjozk

Nov 16, 2007 | Whirlpool GH7145XF Microwave Oven

Not finding what you are looking for?
Microwave Ovens Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Panasonic Microwave Ovens Experts

William Miller
William Miller

Level 3 Expert

8820 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Devabhakthuni...
Devabhakthuni...

Level 2 Expert

224 Answers

Are you a Panasonic Microwave Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...