Question about Jl Audio 250/1 Car Audio Amplifier

1 Answer

I want to know if it is possible to connect two JL Audio 250/1 amps together to power three subwoofers.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 85 Answers

I hate to be the barer of bad news but no I do not believe it is possible to do that and you will probably fry both amps if you attempt it.
But you can connect three subs to one of them

Posted on Nov 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Installin car systems


you dont want to connect both of those amplifiers together. You could run them separately to separate subs or the jl to your sub and your alpine to your front speakers. But you dont ever want to mix and match amps to the same sub. Even if you had 2 jl500/1's you wouldnt want to just hook them up together. Because they both have to be putting out the exact same amount of power. Which no 2 amps are ever exactly the same. Some companies make bridges to properly connect 2 exact amps together. I Hooked up 2 JL 1000/1's to each voice coil on a 13.5 W7 and i smoked the sub. So i definitely dont reccommend doing it unless the amps are conneccted to separate things.

Apr 28, 2010 | Jl Audio 500/1 Car Audio Amplifier

1 Answer

My amp only powers on it gives no power to my subwoofers


1st check to see if the RCA's are plugged in if they are make sure the speakers are plugged in. Check at the amp and at the sub Alson check the input voltage switch. JL Audio Slash series amps have a high/low switch for your input voltage. And the last thing I can think of is if your using a remote wire to turn the amp in make sure the signal sensing switch is off. If your not using a remote wire turn it on....Hope this helps

Mar 29, 2010 | Jl Audio 250/1 Car Audio Amplifier

1 Answer

JL audio 250/1 not powerful enough for pioneer TS-W307D4?


you should move up to more power....underpowering subs is bad! try not to go under the subs rms by 5o watts?

Jul 02, 2009 | Jl Audio 250/1 Car Audio Amplifier

1 Answer

1 10 jl jl 250/1 mono block amp cuts off an on help


your subwoofer is wired incorrectly to your amplifier. Figure out which ohm load of subs you have and then what ohm load options your amp is stable at. Next go to either the Crutchfield website. find their learning center. go to subwoofer wiring diagrams. or go to www.the12volt.com and find their section on it

Jun 11, 2009 | Jl Audio 250/1 Car Audio Amplifier

1 Answer

My Subwoofer cut in and out intermittently how do I stop this?


Take out the actual cone and check the connections to the terminals.

Check earth connection!


Apr 04, 2009 | Jl Audio Slash v2 250/1v2 Car Audio...

1 Answer

Wire three 10" jl subs to jl e1200


what is the impedance of your woofers it will be a number with an Omega symbol. Looks like a horseshoe next to your woofer . Like this JL Audio 10W1v3 8ohm. Please, Please tell me you bought 8 ohm woofers JR?? Because if not, it ain't gunna happen.. If you did buy 8 ohm woofers than wire them in parrellel which means all the +'s together and all the -'s together giving you a final impedance of 2 ohms and your amp will think your a car audio GOD... But if not be ready to smell plastic burning where your amp used to be.... let me know i can walk you thru the wiring but let me know what you have. ok. mark

Mar 18, 2009 | Jl Audio E1200 Car Audio Amplifier

3 Answers

Jl audio 250/1 thermal light


Disconnect all speaker wires from the amp and disconnect the RCA cables from the amp. If it still goes into protect mode, use a multimeter to confirm that you have 12v on the B+ and remote terminals. Place the black meter probe on the ground terminal of the amp when measuring the voltage. If the voltage is sufficient and the amp goes into protect, it will have to be repaired. JL only accepts repairs from authorized dealers. You'll have to find one in your area or you'll have to find a repair shop willing to work on JL amps.

Let me know if you have any other questions.

Oct 15, 2008 | Jl Audio 250/1 Car Audio Amplifier

1 Answer

My jl Auido 250/1 amp


You may have a bad output on the amplifier. I would recommend taking it to a local electronics repair to have fixed, or visit a local stereo shop - preferably a JL Audio dealer. Visit their website at www.jlaudio.com to find a dealer near you. You can have your amplifier sent in to JL Audio for repair by an authorized dealer and you'll get a warranty on the repair work.

Sep 27, 2008 | Jl Audio 250/1 Car Audio Amplifier

3 Answers

How should I wire my 3 subs to the 500/1 amp???????


First of all how many ohm's are each subwoofer rated at . Are the subwoofers dual voice coil or single voice coil. Once I know that I can help you. I think the JL amp is not recommended below a 2ohm load.

Mar 16, 2008 | Jl Audio 500/1 Car Audio Amplifier

Not finding what you are looking for?
Jl Audio 250/1 Car Audio Amplifier Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jl Audio Car Amplifiers Experts

matthew walsh

Level 1 Expert

69 Answers

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1042 Answers

Are you a Jl Audio Car Amplifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...