Question about Minolta magicolor 2300W Laser Printer
I have a minolta magic color 2300 dl printer. I need to print legal size documents and I receive a message that says "put media tray 1 plain paper legal" I have put legal paper in tray and it still shows error and won't print. What do I do?
I had the same problem one time, they told me to pull out all of the toner cartriges, power off, power on, power off, replace all cartridges and the problem went away.
Who knows why. If this doesn't work....
Call Konica Minolta tech support.
They were pretty helpful to me.
Posted on Jan 06, 2008
The service manual is here: magicolor 2300 Series Service Manual
To get a technician near to you, use service locator pages below:
Sales/Service Locator Search | Konica Minolta
Sales/Service Locator | Konica Minolta Business Solutions, U.S.A.
Posted on Apr 01, 2009
The instructions for this are posted on inside, back-left of the front panel when open. As indicated, push the green button in the lower-left corner with an embossed "1" next to it. Then, turn the green knob next to it with an embossed "2" next to it until the next cartridge is fully visible and the button from step 1 pops back out. Repeat step 2 until the correct cartridge is in place. Then pull the green handle above and to the left of the cartridge.
Posted on Aug 31, 2009
SOURCE: My minolta magic color 2300dl
Please check the instruction manual, if it helps…
Let us know if you have something more to know else accept the suggestion.
Thank You for contacting Fixya.com
Posted on Jun 23, 2010
Have you seen status like over 90% remaining.Not sure with your printer over 50% may also be a benchmark to show that it is more than half full.If you say that status is incorrect , then
Sounds like a toner sensor problem.
Remove the OPC drum and all the toner cartridges. Each cartridge has a little green circuit board chip with three gold contacts. When the toner carousel rotates into place those contacts move over the toner sensor. Look down into the printer on the right side underneath where the toner cartridges go and you will see a little white & black rectangular sensor with three thin wire like contacts. Your problem may be simply that they are dirty. I doubt that the contacts on the cartridges themselves are dirty if you get the so they are not recognising correct status.
VERY CAREFULLY (these contacts are very flimsy) wipe the wire contacts and push on them with a tip of a pencil. They should move in and spring back when you let go. They also should be reasonably straight.
If it looks good, put everything back together and try it out.
Posted on Dec 12, 2010
Tips for a great answer:
Nov 14, 2009 | Konica Minolta magicolor 2300DL Laser...
Aug 19, 2009 | Konica Minolta magicolor 2300DL Laser...
Apr 01, 2009 | Minolta magicolor 2300W Laser Printer
263 people viewed this question
Usually answered in minutes!