Technical Support, Instructions & Repair Service

Back to: 

Tags:

RCA P46924 46 in. Rear Projection Television

*** I have to configure Colors with each power on....


posted by SPMoore on Dec 29, 2006


I have a RCA 46" rear projection TV ( about 1993 model ). Each time I turn on the TV I have to adjust the colors and focus to get the picture to be viewable. Is there something I can do so I will not have to adjust the picture so I can watch the TV. I am able to adjust the picture when I open the back of the TV and use a screw driver and turn the adjusters on the far right side of the TV. I put a mirror in front of the TV so I can see it. There are 6 different things for me to adjust. I turn them until I get the best picture. But when I turn off the TV it seems to RESET and I have to do it all over again. I do not want to have to do this each time I want to wathc the TV. Please advise on what I can do so save the setting.

Sam
SPMoore@nc.rr.com
I have the same problem.
This Problem has been added to the Share Your Expertise Page under "My Work Queue".

Best Solution

posted on Sep 06, 2007
FixYa! (100)

RCAFAN

Rank:Apprentice Apprentice
Rating: 100%, 1 votes
FIX IT. THE NEW ONES WON'T LAST 2 YEARS
Was this solution helpful? Show your Appreciation by rating it:

Thank You!

Was the solution helpful?
Show your appreciation by commenting on *** I have to configure Colors with each power on. ***:


I don't want to Accept this solution

Solution #2

posted on Dec 29, 2006
Not Rated (0)

henlopen

Rank:Wiz Wiz
Rating: 84%, 610 votes
The six controls you appear to be adjusting are the screen and focus controls for each of the three picture tubes. These usually only have to be adjusted as each picture tube ages or when replaced. You may either have a defective "focus block" i.e. the black box you have been adjusting, or the CRT's themselves may be going bad at this age. You will probably be money ahead to just replace the TV with a new HDTV set. At 13 years old, it shouldn't have much life left in it anyhow.
Was this solution helpful? Show your Appreciation by rating it:

Thank You!

Was the solution helpful?
Show your appreciation by commenting on *** I have to configure Colors with each power on. ***:


I don't want to Accept this solution

Can you Help with these Projection Televisions problems?

RCA P46924 46 in. Rear Projection...
I have a 1990 RCA Projector TV. Model #P46100TN. The...

RCA P46924 46 in. Rear Projection...
I had a recent power outage. My 52" RCA P52721LVmodel...

RCA P46924 46 in. Rear Projection...
tv turned off now want come back on at all

RCA P46924 46 in. Rear Projection...
when tv is turned on it has a strong red tint and a blurry...

RCA P46924 46 in. Rear Projection...
all of a suddeen the audio disappears and white noise is...

Loading problems.

Repair Service

Find Projection TV Repairman Near You:
Browse the Repair Directory
Repairman, Get Listed FREE

When the original poster rates a solution that was given to his own problem, that rating is locked!
X

Are you sure the solution content is Inappropriate?
   
Tech buddies can communicate directly to answer questions. Become a Tech Buddy and have direct access to your favorite expert for FREE!