I have accessed the web interface for this printer. However, when I try to access the NIC settings, it asks for a user name and password. Does anyone know the default login and password for the NIC settings?
The problem is the printer used to be on a domain and there are several settings, such as DNS, that I need to change. I had to go through the printer's LCD to change the IP address to work on our network, but I cannot find any more advanced settings in the menu. I assumed from the beginning I would have to work mostly in the web interface. Until I have these settings fixed, I cannot scan-to-email. Please help!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
To re-enable the Console access requires the SW2900 series to be reset to its default settings via the WEB INTERFACE
- Web Interface
- Device >Configuration >Initialize To
change the Default User "ADMIN" password it is necessary to use the
-Once the unit has successfully booted and the prompt presented
-Enter "password" (without "")
-Enter "admin" when the system prompts for User
-Press the "Enter" key when the system prompts for "Old Password" (the ADMIN password was reset by the Web Interface commands)
-Enter "" when the system prompts for the New Password (where "" is the new product ADMIN password)
-Enter "" when the system
prompts to confirm the New Password In order to complete the
configuration it is necessary to save the configuration via the WEB
-Device > Configuration > Save Symptom:
SW2900 Baseline Switch - Default console access disabled following password change
From the web interface, the default user "admin" password is changed and console access is disabled Cause:
When applying the new password, by default
the service-type is set to "telnet". When applied, the default
"terminal" setting is removed thus disabling console access.
You might try returning the printer to factory default settings.
I have seen printers get 'bugged' up from power hits. And have seen the nic card ability to access through the internal web page, but not able to access the printer settings page.
If you know the IP address, http the web page of the printer. See if you can see just the Nic card, or completely into the printer setup.
If you have to place a password, it is 1234(factory default password).
If you cannot see the internal setup of the printer, then I would default the printer
If you know the IP address, connect the printer with a laptop using a cross cable. Go to the printer web page by typing the IP address of the machine in the Internet explorer. Browse the menu under network setting and save after you change the gateway