Question about Brand Remote Start/keyless/car Alarm Very Sleek

3 Answers

Spy car alarm manual

Looking for a spy car alarm installation manual not sure on model number but got photo

Posted by on

  • liverpoolfc May 11, 2010

    i need to know how i can(accordin to the manual) reprogram the two transmitters again. recently the two transmitters decided to stop working. replaced batteries as well but to no avail.

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Forget the advice on how to steal a car. It's pointless and does nothing to answer your question. I suppose alicantecoli is proud of his abilities (I used to be too, but I don't do that anymore), however he is a fool if he thinks a 2-Way alarm is useless. While it may only take him minutes to disarm the alarm (waaaaay too long), with a 2-Way system & GPS tracking it would only take me seconds to find it again. Or you could use the silent alarm feature, allow the car to be stolen and immobilise it in the middle of the road. Beside all of this, a simple set of relays properly wired to monitor the alarm system power status can turn those few minutes into an hour or two. Anyway, to your question.

The install manual for the (rebranded) Spy 2-Way Car Alarm is a pathetic chinglish translation printed on a single sheet. It would do you no good unless you have some experience with electronics, and a working knowledge of your car's wiring. That being said, here's the wire colours for you:

6-Pin Connector:
Purple : A/C
Brown: On
Yellow: Start
Red: 12v+
Black: 12v-

12-Pin Connector:
Central Locking - it depends on the type as to how you wire it...
Yellow: Nc
Y/Black: No
White: Com
W/Black: Com
Orange: Nc
O/Black: No

Brown: Flash Lights
Brown2: Flash Lights
R/Black: Trunk/boot release
Red: Siren

8-Pin Connector:
Red: Window roll-up
Green: Side-door + trigger
Blue: Side-door - trigger
Yellow: Engine cut-off
White: Acc
Orange: Foot-brake
Purple: Handbrake
Grey: Start-sensing

2-Pin White: LED
2-Pin Black: Temp. Sens.
3-Pin White: Shock Sens.
3-Pin Black: Microwave Sens.
These four plug in in this order: 2PW, 3PB, 2PB, 3PW

Inside the unit (under the sliding cover on the top) there are three jumper settings: Elec/Pneu CL, Lights Flash/No Flash, Auto-arm/No auto. The first of each pair is the default setting.


Hope this helps. That, honestly, should be all you need. If you do need more info, then please DO NOT TRY TO INSTALL THIS ITEM YOURSELF. As it says on the manual, "Install the system by a professional people."

Posted on Feb 18, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

I NEED AMANUAL FOR A SPY ALARM MODEL #LC308B

Posted on Dec 11, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 21,990 Answers

Forget the boy racer add on they are useless,if i want to pinch it it will take me minutes to silence and by-pass it ......buy a steering lock that fits over the steering wheel complete so air bag cant be half inched either and never leave anything in car worth nicking ,these sort of things take too long to remove,and if you put car into a garage for servicing never leave the key for steering lock with the car keys .Another and cheaper way is to put a switch in power cable to the fuel pump and place switch where only you know where it is behind facia or seat .now that slows them down.Best way to half inch a car is to pick it up with a breakdown truck .no body bats an eyelid

Posted on Nov 22, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How I can get a service repair business for the diagnosis of a Clifford car alarm system?


First replaced the batteries, you may find a CR2032 in there easy to replace then try before blaming any other components

Aug 03, 2014 | Brand Remote Start/keyless/car Alarm Very...

1 Answer

I bought a Spy brand one-way car alarm/remote start for my wife's 09 Camry. Everything is installed, and works except for the remote start.


Installations of this nature are usually reserved for professionals. However, get out your installation manual. You will also need two single pulse double throw relays and some diodes. First you will need to locate the ground when running.This wire might be labeled " (-) third ignition". The first relay for the starter will be wired like so: starter wire to 86, fused 12 volts to 87, 30 out to vehicle second starter wire, 85 to ground when running. The second relay will be wired 86 to vehicle ignition, 87 to fused 12 volt, 30 out to second ignition, and 85 to ground when running.

Jan 22, 2013 | Brand Remote Start/keyless/car Alarm Very...

1 Answer

Remote start/ 09 Camry installation


what brand is alarm? hood pin IS required,ground hood pin lead try to remote start

Jan 18, 2013 | Brand Remote Start/keyless/car Alarm Very...

1 Answer

I need a manual installation guide for a Spy 5000m C1 MODEL


This is the only site I know of that has a manual for the install
and user instructions for this alarm. This alarm is hard to install
but the manual shows you how to do it with diagrams.

http://userguides.50webs.com/spy_5000m.htm

Sep 23, 2010 | Brand Remote Start/keyless/car Alarm Very...

1 Answer

I've installed the spy alarm system a couple months ago and it never worked right. I have to constantly press the buttons for it to do what i want it to do..most of the time, the system don't react to my...


There could be an issue with the antenna. Is it mounted on the windshield? If so, try moving it to a different location. You didn't mention the year, make, model of your vehicle but, some cars have a filament in the windshield that interferes with RF signals.

Sep 15, 2010 | Brand Remote Start/keyless/car Alarm Very...

3 Answers

Spy 5000m remote start issues


You need to adjust the tachometer sensing wire, it usually wraps around a spark plug wire so I can sense when the car starts. On my spy alarm, the wire was grey. Hope this helps.

May 05, 2010 | Brand Remote Start/keyless/car Alarm Very...

1 Answer

Hello¡¡¡¡¡ I can't program remote control of explorer 2005, the original alarm is code alarm. What can I do? Thanks


Try looking for a model number on the control unit. Use this number to download the owners manual for the Code Alarm.

Mar 05, 2010 | Code-Alarm Code Alarm Transponder

Not finding what you are looking for?
Brand Remote Start/keyless/car Alarm Very Sleek Logo

14,093 people viewed this question

Ask a Question

Usually answered in minutes!

Top Spy Vehicle Parts & Accessories Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

David Burbee
David Burbee

Level 2 Expert

1868 Answers

Larry Spears
Larry Spears

Level 3 Expert

625 Answers

Are you a Spy Vehicle Part and Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...