ERROR CODE E9 VISION FITNESS TREADMILL T9200 - Vision Fitness T9200 Premier Treadmill

Data Cable issue.

Large Data Cable Symptoms 1. E2 (T9200 & T9250 ONLY) 2. E5 3. E6 4. E9 5. No Elevation or speed function 6. No Elevation 7. No Speed 8. Deck goes to max at start 9. Run away speed Small Data Cable symptoms 1. No power to the upper board 2. Loss of power to the upper board, intermittent shutdown To troubleshoot a bad large data cable for most models - Enter engineering mode (see engineering mode for specific treadmill). If the elevation window in calibrations reads 000 in Px there no signal from the lower board to the upper console.
https://content.johnsonfit.com/inc/uploaded_media/4827226804f82ae5476352ddf9051547/troubleshooting_guide/87fc08ffe3e0caa8a9d3a1b15d59e71d.pdf

..

The "E4" error code on a T9200 Vision Fitness treadmill typically indicates a problem with the incline motor. This could be caused by a malfunctioning motor, a problem with the wiring or connections to the motor, or an issue with the incline sensor or control board.
Here are a few things you can try to troubleshoot the problem:

1. Check the wiring and connections: Inspect the wiring and connections between the incline motor and the control board to make sure that they are securely connected and not damaged.
2. Check the incline sensor: Make sure that the incline sensor is functioning properly and that it is not blocked or damaged.
3. Check the control board: Make sure that the control board is functioning properly and that it is not damaged.
4. Check the incline motor: Make sure that the incline motor is functioning properly and that it is not damaged.

It's important to follow the instructions carefully and if you have any doubts or difficulties, consult the treadmill's user manual or contact Vision Fitness customer service for assistance. It's also important to note that it is recommended to have a professional technician to perform this task as it may cause other issues if not done properly.

If you wish to get some details; check the site linked here. Pull up older posts treadmill . Surf the site with patience.
http://electro-medical.blogspot.com/

If you wish to get some details; check the site linked here. Pull up older posts For treadmill error code . Surf the site with patience.
http://electro-medical.blogspot.com/

running belt has bunched up in the middle

please follow this steps and fix it. GOD BLESS YOU

May not be much help, but try cleaning all the sensors you can find. May be some lint if an optical sensor, or may have lost a magnet if a magnetic sensor???

see this place and download the instr.manual www.iconservice.com or www. fitness.manualsonline.com

God bless you

see this video for way.


God bless you