- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
turn off scanner hold down the state/highway the number 2 and 9 then while holding the 3 buttons turn your scanner back on while holding the state/highway, 2 and 9 buttons if you did everything correct you will see a clear message show up and about 2 seconds later hear a beep
Make sure you have fresh batteries,turn on the unit,press manual,enter the channel number,press manual,enter the frequency you want,press E enter,if you make a mistake, press CLR to erase. Get the frequency,s for your state at RadioFreq.com. ..hope this helps..
Just to verify you are trying to program frequencies the scanner is able to receive. This unit is limited to the following freq range. 25.0-27.995 28.0-29.695 29.7-49.995 50.0-54.0 5 108.0-136.9875 137.0-143.995 144.0-147.995 148.0-174.0 5 406.0-419.99375 420.0-449.99375 450.0-469.99375 470.0-512.0 6.25
If the frequencies your are trying to enter or outside these bands you will get a error.
Next Direct Entry Mode Programming Press Func. + PGM Press E to enter ch in current location To change location pres func + Up ^ or down key to choose location then press E Enter your freq then press E