Question about Maytag MER6772 Gemini Electric Kitchen Range
I have a MER6770AAC. The lower oven bake element is only partially working. All except for the last section that runs parallel to the back of the oven turns red. I assume that's not normal correct?? I replaced the element today and much to my dismay, it did the same thing. I called the store where I bought the element and he suggested that it's a power problem. I checked across both leads and had 240. I also checked across the ground to each lead and had 120. Seems fine there.
Any suggestions??? Thanksgiving is a week away and I don't want the turkey cooking unevenly. Thanks for all your help!!
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Sounds like you have it figured, need to spend some moola..........
You can ohm out the sensor to the oven should be about 1100 ohms at room temperature.((the sensor is the little rod with two wires attached to it sticking in the oven, as temps change resistance changes which is read by the board) The upper and lower oven sensors are probably the same,you could just swap them to test, but probably not necessary,might also be confusing if you do not do a lot of testing on a regular basis. Remember to unplug unit for safety.
The bake element if it was not bad should be about 20 ohms, bad would read open........
Posted on Feb 21, 2010
Tips for a great answer:
Dec 05, 2014 | GE Ovens
Nov 13, 2013 | Electrolux Ovens
Nov 13, 2009 | Ovens
May 27, 2009 | Ovens
Mar 04, 2009 | GE Ovens
Mar 03, 2009 | Amana AOES3030SS Oven
Jan 28, 2009 | Maytag MER6772 Gemini Electric Kitchen...
Sep 10, 2008 | Maytag MER6772 Gemini Electric Kitchen...
62 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: