Question about Sony FD Trinitron WEGA KV-24FS120 24" TV

1 Answer

TV turns on......eventually

Tv was working fine till about 2 weeks ago. now i have to hit the power button many times before the tv will turn on. hit power button tv clicks, red light blinks, tv clicks again rinse and repeat till the tv turns on

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 81 Answers
Re: TV turns on......eventually

Check for a bad cap ,relay sound ok or could be a bad solder connection in the power supply at the regulators

Posted on Dec 15, 2006

Add Your Answer

0 characters

Uploading: 0%


Complete. Click "Add" to insert your video. Add


3 Points

Related Questions:

2 Answers

Won't turn on led flashes green 8 time

Sounds stupid but I've had this issue with 2 different brand TV's and I unplug them for 5-10 minutes and then they are fine. I just had this happen just a week ago with a TV again.

Jul 14, 2014 | Sylvania 6842PE TV

1 Answer

I have a '96 samsung 25" tube tv. model # TXE2546 - series # 3CAG700429. when i turn it on it has always made a click sound a couple of seconds afterwards. the "power & timer" led light flashes about...

This problems the FBT-the Flyback Transformer have cold solders.Must resolders the FBT.The right side wall of the FBT-the "H" horizontal transistor,must be also resolder too.

Oct 18, 2010 | Samsung TXJ2754 27" TV

1 Answer

I hooked the ps3 to the philips tv. turned on the ps3, AV1 displays in the corner. Nothing else happens, I am expecting the ps3 logo

give this a try...

Leave the TV running, go over to your PS3 and turn it off.

Once its off, hold the power button down till you hear a beep, KEEP HOLDING THE POWER BUTTON till you hear a double beep. The PS3 will shut itself off.

Give the device a couple of seconds, then hit the power button one last time (just turn it on, you don't have to hold it).

If all went right, your baby is back up and running...

Oct 11, 2010 | Philips 27RF50S 27" TV

1 Answer have to hit the power button multiple times to turn off tv 2.when watching a channel the tv starts scrolling through the channel set up. It eventually stops but then you can't use the remote and have...

Sounds like a tact switch problem at the front of the set. The switches are just behind the front panel buttons. Don't replace just one. Replace them all. They are not expensive and will avoid trouble later. If one switch is getting stuck internally, nothing else will work including the remote.

Oct 15, 2009 | RCA Standard (CRT) Televisions

1 Answer

Tv wont turn on

Same Problem. TV was purchased from Sams Club about 2 or 3 years ago. workede great unti llast week. We were watching tv and it just shut off. The power button on the tv started to get soft were you had to push hard or just use the remote. My guess its something with the wsitch.

Jan 28, 2009 | Sylvania 6427TE 27" TV

2 Answers

Sony Wega 40" TV will not turn on, standby light blinks 6 times repeatedly

Hello,For model KV-40XBR800,

Pls check following area.

Low HV Shutdown:
On the D Board.
Check IC8004/pin 7 should be 7.4v.
Check IC8006/pin 2 should be 2.5v if lower will trigger shutdown by causing pin 1 to turn on.
Check IC8006/pin 3 reference voltage 2.2v.
IC8006/pin 1 normally at 0v. If high
turns D5007 ON which turns the latch circuit Q6532,
Q6530, and Q6527 ON and turns the AC relay RY6501 OFF.

And NOTE: 6 blinks also can be Low B+ protection.

Unregulated 7.5 v from the power supply to 5v reg IC504 on the A Board. 5v to M Board Q2314

to CPU IC2300/pin 43. If 5v missing set will shutdown with 6 blinks.

Good Luck

Oct 05, 2008 | Sony FD Trinitron WEGA KV-32FS120 32" TV

2 Answers

It takes 5 to 7 minutes to turn on my Magnavox HD TV

IFyou feel confident and can locate switch mode power supply with back removed.
Try warming switchmode power supply before turning TV on.
If TV turns on normaly then there are some small capcitors that are a common cause of this fault.
Otherwise look for DRY or CRACKED solder jointson PCB
BUT DON'T do any of the above if your are not confident send it to a TV repaiman.

Sep 11, 2008 | Philips Magnavox MS2530C 25" TV

1 Answer

TV shuts off after few minutes

tap it on its side then try to turn it on and see if it stays on if it does bad solder connections

Aug 11, 2006 | Sanyo DS31520 31" TV

2 Answers

Progressive power up problem

Yeppers. Sounds like the standby power supply has a bad capacitor in it and the regulator Ic is defective. These parts should only be replaced by quilified technician as there is very high voltage inside these sets. Good Luck

Jun 14, 2006 | JVC AV-K29MX1U 29" TV

Not finding what you are looking for?
Sony FD Trinitron WEGA KV-24FS120 24" TV Logo

Related Topics:

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

66413 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1187 Answers

Are you a Sony Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides